3Com WL-560 manual Secondary Radius

38CHAPTER 3: CONFIGURING THE BRIDGE

Table 12 RADIUS Authentication Server Settings (continued)

Secondary RADIUS	Enter the IP address of the secondary RADIUS Authentication
Server	Server. Make sure this address matches the address set in the
	RADIUS Authentication software.
Secondary RADIUS	Enter the port number of the secondary RADIUS
Port	Authentication Server. Make sure this number matches the
	number set in the RADIUS Authentication software. The
	default port is 1812.
Secondary RADIUS	Enter the password of the secondary RADIUS Authentication
Secret	Server. Make sure this password matches the password set in
	the RADIUS Authentication software.

Changing SNMP Under System Configuration, click SNMP to display and change settings Settings for the Simple Network Management Protocol.

To communicate with the Bridge, the SNMP agent must first be enabled and the Network Management Station must submit a valid community string for authentication. Select SNMP Enable and enter data into the fields as described below. When you are finished, click Apply.

Table 13 SNMP Settings

Setting	Description
SNMP	Enables or disables SNMP.
Contact	Sets the location string that describes the system location.
	Maximum length: 255 characters.
Community Name	Specifies a community string with read-only access.
(Read Only)	Authorized management stations are able to retrieve MIB
	objects. Maximum length: 23 characters.
Community Name	Specifies a community string with read-write access.
(Read/Write)	Authorized management stations are able to both retrieve
	and modify MIB objects. Maximum length: 23 characters.
Trap Destination	Enter the IP address of the trap manager that will receive
IP Address	these messages.
Trap Destination	Enter the community name of the trap manager that will
Community Name	receive these messages.