3Com WL-560 manual Routing Cable Under the Cradle

Page 18

12CHAPTER 2: INSTALLING THE BRIDGE

2Route the power and Ethernet cables through the large opening in the cradle. Figure 5 shows a cable being routed under the cradle.

Figure 5 Routing Cable Under the Cradle

3Connect the power and Ethernet cables to the ports on the Bridge.

4Snap the Bridge onto the cradle.

Installing the For additional security, install the locking bar in the cradle after the Bridge Locking Bar is mounted to the wall. Use your own lock to secure it in place.

To install the locking bar:

1Insert the locking bar through the opening in the side of the cradle, as shown in Figure 6.

Figure 6 Inserting the Locking Bar

.11a .11g .100 .10

Image 18

Contents 3Com 11a/b/g Wireless Workgroup Bridge User Guide 3Com Corporation Campus Drive Marlborough MA USA Contents Configuring the Bridge END User License Agreement Regulatory Information Page About this Guide Documentation ConventionsRelated FollowingDocumentation documentation Product Registration Support Introduction 802.11a 802.11gNetwork ConfigurationNetwork Configuration and Planning PlanningExample ConfigurationsWireless Infrastructure Network Workgroup Ad-Hoc NetworkUnpacking BridgeBridge Deciding Where to Place the Bridge Wall-Mounting the BridgeRouting Cable Under the Cradle Securing the Locking Bar Connecting Connecting the PowerAbout the Client List Connecting to a Hub Connecting the BridgeNetwork printers in areas that are not wired for Ethernet Indicators LEDExternal Antenna Need to ConfigureAttaching An Determining if youDetermining if you Need to Configure the Bridge Networks without a Dhcp ServerBridge Default Settings To Wireless Client InfrastructureUsing the 3Com Installation CD Using the 3Com Installation CDInstalling the Bridge Configuring the Bridge Infrastructure Using the 3ComWireless Device ManagerClick Configure Using the 3Com Wireless Infrastructure Device ManagerButton Description Using ManagementSystem Clearing Applying System Configuration Settings Moving to a new configurationSystem Properties Server, select Obtain an IP address automatically and click ApplySelect Wireless Client Infrastructure to associate with an Select 802.11a to set the Bridge to operate with eitherService Area Select Specify the Wireless LAN Service Area to allowExternal and one internal antenna this setting Being used, click Long Wi-Fi InteroperableSet the Data Preamble No Security Open System 40/64-bit Shared Key WEP104/128-bit Shared Key 128/152-bit Shared KeyOr Disable AESSecondary Radius Using the Configuration Management System Configuring Operation Mode About UartConfiguring Uart Settings Configuring Network Serial Port SettingsApplying Settings ResetUnder Tools, click Restore Factory Defaults Or with the Bridge out of the cradleUsing FTP default Using TftpUsing Http Under Tools, click Backup Wireless Workgroup BridgeUnder Tools, click Restore Wireless Workgroup Bridge Summary Page Problems DiagnosingTroubleshooting Uninstall 3Com Wireless Infrastructure Device Manager DisconnectingUninstalling Disconnecting the BridgeUpgrading Bridge FirmwareRegister Your Service BenefitsSolve Problems Product to GainAccess Software WarrantyProfessional Services Purchase ExtendedDirectory of 3Com resources by region at Contact UsLatin America Telephone Technical Support and Repair END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Industry Canada IC Emissions Compliance Statement Europe EU Declaration of Conformity Bipt Indoor/Outdoor