
3. Placing Documents |
| 3 | Fan the pages of the document to be scanned, and then turn the document |
|
| so that it is upside down. | |
|
|
|
|
There are two methods for feeding documents, the Page Separation mode and Bypass mode. Feeding pages continuously from a stack of documents placed in the feed tray is called the Page Separation mode. Feeding documents one sheet at a time or feeding documents consisting of multiple pages that are attached, is called the Bypass mode.
The document feed method can be changed by moving the feed selection lever.
Feeding in the Page Separation Mode
1Switch the feed selection lever to
(Page Separation).
CAUTION
When placing documents into the feed tray, take care not to cut your hands on the edges of the paper.
4Place the document face down, with the top fed through the scanner first.
2 Adjust the document guides to fit the width of the document to be scanned. |
IMPORTANT
There is a load limit mark ( ) on the document guides. Do not stack documents higher than this mark (approximately 50 sheets of 20 lb bond (80 g/ m2) paper.) Doing so may cause a paper jam.
22 |
|