
Feeding Options
This section describes the procedure for selecting the method for feeding documents.
1Click the [Others] tab in the Properties for Canon
• | NOTE |
Details of each feeding method are indicated below. |
[Standard Feeding]
This feeding method is good for scanning small batches of documents that are placed one batch at a time. Scanning stops when the documents have been scanned.
[Panel-Feeding]
This feeding method is good for scanning batches of documents of different sizes. After placing the documents, press the Start button on the Scan Panel to start scanning, and press the assigned Stop button to stop scanning.
yWhen scanning documents with different sized pages, after placing the documents, you can adjust the document guide position.
[Automatic Feeding]
This feeding method is good for scanning batches of the same sized documents. Scanning starts when the scanner detects the placed documents, and stops when you press the Stop button.
yWhen [Automatic Feeding] is selected, the Setting button is enabled to allow setting the delay time from when a placed document is detected to when scanning starts. The delay time can be set from 0 to 60 seconds.
Batch Separation (ISIS driver only)
When the separation timing to use when scanning starts with batch separation enabled in the application. (If [Standard Feeding] is selected, batch separation is disabled.)
[Auto]
Document batches are separated automatically.
[Panel]
Document batches are separated when [Batch Separation] on the Scan Panel is pressed. (See "Using the Scan Panel," on p.30.)
53 |
|