Brother WL660 manual Test

English

CHAPTER 3 PRINTER CONTROL

When the printer is in the Ready mode and the printer does not receive data for a certain period of time (time-out), it automatically enters sleep mode. The default time-out has been factory set for 5 to 15 minutes.

To awaken the printer to Ready status, press the READY↔SLEEP switch again. Receiving a document automatically awakens the printer and causes it to start printing.

✒Note

∙This printer has no power switch. The sleep mode handles the power control.

∙When the printer first enters sleep mode, the fan will not stop until the printer engine has cooled down.

∙Sleep mode allows the print engine to cool, so the temperature of your room and the amount of time the printer has been in sleep mode affects the warm-up time. Warm-up time can take about 60 seconds. The READY lamp blinks to indicate that the printer is warming up.

∙You can change the time-out for sleep mode with the printer driver. For more information, open the Setup dialog box of your printer driver in the Windows Control Panel and choose Help or press the F1 key.

Test Page

When you hold down the READY↔SLEEP switch for about 3 seconds, the printer will print a test page. You can check the print condition or print quality with it.

3–3