Brother WL660 manual Chapter Troubleshooting, Alarm Indications AT a Glance, Operator Calls

English

CHAPTER 6 TROUBLESHOOTING

CHAPTER 6

TROUBLESHOOTING

ALARM INDICATIONS AT A GLANCE

Operator Calls

If an error occurs, the printer indicates an “operator call’ by blinking the ALARM lamp. The status monitor appears on your computer screen to indicate the error.

The printer can recover from most errors if you take the proper action following the displayed instructions.

Operator Call	Action
Cover Open	Close the top cover of the printer or press firmly on the
	multi-purpose sheet feeder to make sure it is properly
	installed.
Mis Feed	Reinstall the paper.
Paper Empty	Load paper into the printer referring to Chapter 2.
Paper Jam	Clear the paper jam referring to the next section “PAPER
	JAMS” and press the READY ↔SLEEP switch if the
	printer does not automatically resume printing. Do not
	simply pull the paper out before referring to the next
	section.
Bi-Directional	Check that the connection between your computer and
Error	printer is secure and correct, and check the interface cable,
	to ensure it is screwed into the back of the computer and
	secured by the clips on the printer's port.
Print Overrun	∙ Turn error recovery operation on in the Setup dialog
	box.
	∙ Reduce the complexity of your document or reduce the
	print resolution.
	∙ Expand the printer memory by installing one of the
	optional memory boards.
Toner Empty	Replace the toner cartridge with a new one.

✒Note

If the printer does not operate as you expect it to, it is recommended that you unplug the printer, wait a few seconds and then plug it in again. If you still have problems, consult your dealer or our authorized service representative.

6–1