3Com Server manual Changing the Test Setup, Getting Help If a Test Fails

Page 27

DOS Diagnostic Tests

4-5

Changing the Test Setup

You may want to change certain aspects of a test; for example, the number of times the test repeats or whether the test halts when it encounters an error. If you need to change the test setup, follow these steps:

1From the Test menu, select Test Setup. Or, in the Run Tests dialog box, select Test Setup.

2Select any Test Setup dialog box ﬁeld.

3In the Group Select box, select a test group.

4Change the test setup.

For example, if you select the Group 1 tests, you can make the following changes to the setup:

■In the Group X Tests box, select a test. Press the spacebar to enable or disable an individual test.

■In the Repetitions box, specify the number of times you want to run the tests, or select the Continuous option.

■In the Errors box, press the spacebar to select or deselect the Halt on Error parameter.

5Select OK.

6From the Test menu, select Run Tests. Select Start to run the tests.

Getting Help If a Test Fails

If a test fails, the NIC may not be defective. The problem may be incorrect option settings, option settings that conﬂict with the settings of other boards, or improper installation.

If a DOS diagnostic test fails, you can get additional information as follows:

■From the Run Tests dialog box, select the test that failed, and press Enter.

■Select Zoom and press Enter.

Image 27

Contents Part No -1128-000 Published February 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Configuration Figures Tables Text Conventions Installation RequirementsLifetime Limited Warranty Belgium, Netherlands, Luxembourg Asia Italy, Greece, Spain, Portugal, MaltaAustralia, New Zealand Japan Sweden, Finland, NorwayAbout this Guide ConventionsIcon Description Convention Description Related Documentation1Basic TR-in-FE System Introduction2Larger-Scale TR-in-FE System Safety Precautions Hardware InstallationInstallation Requirements Installation InstructionsUnpack and inspect the NIC Insert the 3C395 NIC in a PCI slot Remove the computer coverTurn on the PC and check the NIC LEDs 2Connecting the CableBefore You Install Software Before You Install SoftwarePage Obtaining the Latest Drivers Installing the NetWare Server DriverAt the console prompt, enter NetWareInstalling the Windows NT Driver Windows NTAt the following prompts, make these selections 4CHAPTER 3 Software Installation Troubleshooting LEDsColor Flashing Steady Off DOS Diagnostic Tests About the Conﬁguration and Diagnostic ProgramTest Description To start the tests, press Enter Boot the PC under DOSRunning Group 1 Tests From the Test menu, select Run TestsRunning the Group 3 Test Getting Help If a Test Fails Changing the Test SetupSymptom Tip Further TestingSymptom Tip Page Option Description Default Available Settings ConfigurationChanging Conﬁguration Settings From the Install menu, select a NIC as followsSelect options and select settings To save settings, select OK When all changes are complete, exit the programChanging the Windows NT Registry Page Specifications Figure A-1 shows the RJ-45 connector pin assignments RJ-45 Connector Pin AssignmentsOnline Technical Services 3Com Bulletin Board ServiceWorld Wide Web Site 408 654 3ComFacts Automated Fax ServiceAccess by Analog Modem Access by Digital ModemPress Return to see the 3ComForum main menu 3ComForum on CompuServe Online ServiceSupport from Your Network Supplier Log on to your CompuServe accountSupport from 3Com 3Com Mediterraneo Regional Sales Office Telephone Number 3Com GmbH3Com Iberia 3Com Latin AmericaCountry Telephone Number Fax Number Returning Products for RepairNumbers IndexURL B-1 3Com Corporation Limited Warranty FCC Class B Statement FCC Declaration of Conformity