4.18 Using the AdderLink extender
Refer to the installation guide provided with your AdderLink extender. The transmitter unit (AdderLink XL) is built into the SmartView XPro so you will only need the receiver (AdderLink XR unit). You may use an AdderLink XR receiver or an AdderLink Gold XR receiver.
When using an AdderLink extender we highly recommend that you set the AdderLink's hotkeys to be different to the SmartView's hotkeys to avoid any confusion
4.19 What to do if you forget your ADMIN password
If you forget your ADMIN account password you will not be able to access the SmartView XPro to add or edit users and computer names. If this unfortunate situation does occur then you can resolve it by performing a complete reset to return the SmartView to its factory default state. A complete reset erases all the user names and computer names that you have setup. You can only perform a complete reset if you have access to both the front and the rear of the SmartView.
To perform a complete reset and return the SmartView to its factory default state:
1)Power on the SmartView normally.
2)Whilst the SmartView is powered on move switch 2 on the rear panel of the SmartView (labelled UPGRADE) to the ON (down) position.
3)Press the USER and the COMPUTER keys together.
4)The green USER display will show 'r' for a few seconds to confirm that a reset is taking place.
5)Return switch 2 to the normal OFF position (up).
SmartView XPro | Installation and Use | Page 58 |