Adder Technology 2XPRO manual To edit the menu names and configuration settings

To edit the menu names and configuration settings:

You may open the XPRODATA.CSV using a spreadsheet program such as Microsoft Excel. The format of a typical file is shown below. You will see that the computer names (rows) are tabulated against the user profiles (columns). To grant a user access to a computer, enter the value 1 in the box that is common to the computer’s row and the user’s column. To deny access, leave this box blank. To add extra users, add additional columns (up to 16 users). To add extra computers, add additional rows (up to 512 computers). The ADMIN user will always be granted access to all computers regardless of the values entered.

USERS		ADMIN		Alan		Jim		Sue		Test
PASSWORDS		password		letmein		hello		logmein		Test
COMPUTERS	PORT
Admin PC	2103		1		1		1		1
Alan's System	2102		1		1		1
Comms Server	3		1				1
Comms PC	4		1		1		1		1
Gateway 1	8		1
Gateway 2	5		1
Test System	15		1		1
Web Browser	9		1				1			1

To restore the saved / edited menu and configuration settings:

1.Connect the serial port on the rear of the SmartView XPro to a serial COM port on your computer using the serial cable supplied with the SmartView.

2.Copy the program XPWRITE and XPRODATA.CSV into the same directory on the PC that is connected to the SmartView’s serial port.

3.Run the program XPWRITE.EXE and follow the instructions given by the program.

4.Make sure that you are logged onto the SmartView as the ADMIN user. From the main selection screen press F1 for More Menus. In the Configuration Menu select Functions. In the Functions menu select Read Data from RS232 port.

5.The SmartView should then receive the configuration data to your computer and load the new menu names and access rights into the menu.

SmartView XPro Installation and Use Page 60