Emerson RTM-ATCA-F120-OPT manual Hardware Preparation and Installation

Page 36

Hardware Preparation and Installation

SFP/SFP+ modules can be installed/removed both while the RTM is powered and non- powered. The presence and also the type of SFP/SFP+ modules is automatically detected.

The maximum power consumption of all installed SFP/SFP+ modules must not exceed 12W.

36	RTM-ATCA-F120-OPT Installation and Use (6806800G29C)

Image 36

Contents RTM-ATCA-F120-OPT Contact Address Contents Contents RTM-ATCA-F120-OPT Installation and Use 6806800G29C List of TablesList of Tables List of Figures List of Figures Overview of Contents About this ManualAbbreviations Conventions About this ManualNotation Description BoldSummary of Changes Part Number Publication Date DescriptionAbout this Manual Safety Notes Electrical InterferenceInstallation Safety NotesOperation SFP/SFP+ Modules Environment Sicherheitshinweise EMV SicherheitshinweiseBeschädigung von Schaltkreisen Umweltschutz VerletzungsgefahrFeatures IntroductionIntroduction Standard Compliances Standard DescriptionFeature Value Mechanical DataOrdering Information Hardware Preparation and Installation OverviewUnpacking and Inspecting the RTM Environmental and Power Requirements Hardware Preparation and InstallationEnvironmental Requirements Power Requirements Requirement Operating Non-OperatingInstalling and Removing the RTM Installing the RTMHardware Preparation and Installation Hardware Preparation and Installation Installation Procedure without Installed Front Blade Close the handles of the front blade Removal Procedure Removing the RTMHardware Preparation and Installation Installing and Removing SFP/ SFP+ Modules Hardware Preparation and Installation Installing an SFP/SFP+ Module ProcedureConnect the network cable to the SFP/SFP+ module Removing an SFP/SFP+ Module Remove any connected cable from the SFP moduleHardware Preparation and Installation Controls, LEDs and Connectors LEDs and Interface Connectors Controls, LEDs and ConnectorsInterface Connectors During RTM installationLEDs During RTM removalFabric Channel Uplinks Location of Ethernet Fabric Channel Uplink Interfaces Face Plate Label Ethernet TypeBase Channel Interface Connectors 2.1.2 1 GBit Fabric Interface UplinksLocation of Base Interface Uplink Interface Connectors 2.2.1 10 GBit Base Interface Uplinks 2.3 SFP/SFP+ Module Hot Swap Controls, LEDs and Connectors Telecom Clocking Connectors Location of Clock Extension ConnectorsSerial Interface Connector Location of Serial Interface Connectors Pin Signal Functional Description Block Diagram Functional DescriptionMezzanine Management Controller Sensor Name Sensor Type Sensor NumberRTM-F120-OPT MMC Functional Description Location of Ipmi Temperature Sensors Functional Description RTM-ATCA-F120-OPT Installation and Use 6806800G29C Emerson Network Power Embedded Computing Documents ARelated DocumentationDocument Title and Source Publication Number Related Documentation Index Index Page HOW to Reach Literature and Technical Support Embedded Computing