Emerson RTM-ATCA-F120-OPT manual Index

Page 65

Index

B

Block diagram 56

C

conventions 10

E

Environmental requirements 26

F

Fabric channel connectors 44, 47

Face plate 42

I

Installation procedure 28

IPMI sensors 57

L

LEDs 43

M

Main features 21

Mezzanine management controller 57

R

Removal procedure 33

S

SFP/SFP+ module hot swap capabilities 50

Standard compliances 23

Supported SFP/SFP+ modules 46, 49

T

Temperature sensors 59

RTM-ATCA-F120-OPT Installation and Use (6806800G29C)

65

Image 65

Contents RTM-ATCA-F120-OPT Contact Address Contents Contents List of Tables RTM-ATCA-F120-OPT Installation and Use 6806800G29CList of Tables List of Figures List of Figures Abbreviations Overview of ContentsAbout this Manual About this Manual ConventionsNotation Description BoldPart Number Publication Date Description Summary of ChangesAbout this Manual Electrical Interference Safety NotesOperation InstallationSafety Notes SFP/SFP+ Modules Environment Sicherheitshinweise Sicherheitshinweise EMVBeschädigung von Schaltkreisen Verletzungsgefahr UmweltschutzIntroduction FeaturesIntroduction Standard Description Standard CompliancesOrdering Information Feature ValueMechanical Data Unpacking and Inspecting the RTM Hardware Preparation and InstallationOverview Environmental Requirements Environmental and Power RequirementsHardware Preparation and Installation Requirement Operating Non-Operating Power RequirementsInstalling the RTM Installing and Removing the RTMHardware Preparation and Installation Hardware Preparation and Installation Installation Procedure without Installed Front Blade Close the handles of the front blade Removing the RTM Removal ProcedureHardware Preparation and Installation Installing and Removing SFP/ SFP+ Modules Hardware Preparation and Installation Procedure Installing an SFP/SFP+ ModuleConnect the network cable to the SFP/SFP+ module Remove any connected cable from the SFP module Removing an SFP/SFP+ ModuleHardware Preparation and Installation Controls, LEDs and Connectors Controls, LEDs and Connectors LEDs and Interface ConnectorsDuring RTM installation Interface ConnectorsLEDs During RTM removalFabric Channel Uplinks Location of Ethernet Fabric Channel Uplink Interfaces Ethernet Type Face Plate Label2.1.2 1 GBit Fabric Interface Uplinks Base Channel Interface ConnectorsLocation of Base Interface Uplink Interface Connectors 2.2.1 10 GBit Base Interface Uplinks 2.3 SFP/SFP+ Module Hot Swap Location of Clock Extension Connectors Controls, LEDs and Connectors Telecom Clocking ConnectorsSerial Interface Connector Location of Serial Interface Connectors Pin Signal Functional Description Functional Description Block DiagramSensor Name Sensor Type Sensor Number Mezzanine Management ControllerRTM-F120-OPT MMC Functional Description Location of Ipmi Temperature Sensors Functional Description RTM-ATCA-F120-OPT Installation and Use 6806800G29C Document Title and Source Publication Number Emerson Network Power Embedded Computing DocumentsARelated Documentation Related Documentation Index Index Page Embedded Computing HOW to Reach Literature and Technical Support