Automation and Drives - SCE
17.The setpoint value, the actual value and the manipulated variable now have to be wired to process values as follows.
Cycle time:
Time between the block call. Should correspond to the time that is set in OB 35.
SP INT:
Setpoint selection through analog input. Has to be normalized to a real format (refer to NW 2)
PV PER Actual value acceptance to analog input channel
LMN PER: Manipulated variable output at analog output
|
|
|
|
|
|
|
| Preface Fundamentals | Discontinuous Action Controllerr | Controller Block (S)FB41 |
| Setting the System Appendix |
|
|
|
|
|
|
|
|
| T I A Training Document | Page 49 of 64 | Module | |||
|
|
|
|
| B3 | |
Issued: 02/2008 |
|
|
| Control Engineering with STEP 7 | ||