Samsung CLP-350 manual Getting Started, Setting up the hardware, Setting up the network

3 Getting Started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:

•Setting up the hardware

•Setting up the network

•Installing the software

•Altitude adjustment

Setting up the hardware

This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps.

1Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays.

The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See page 3.4 for more information.

Place the machine on a flat and stable surface for not letting it tilt more than 2 mm (0.08 inches). Otherwise, it may affect the printing quality.

2Unpack the machine and check all the enclosed items.

3Remove the tape holding the machine tightly.

4Install both the toner cartridge.

5Load paper. (See "Loading paper" on page 4.4.)

6Make sure that all the cables are connected to the machine.

7Turn the machine on.

Caution

When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad printing quality.

Setting up the network

You need to set up the network protocols on the machine to use it as your network printer.

Note

• If you want to use the USB cable, connect the cable between a computer and you machine. Then, refer to the software installation in Software section.

3.1 <Getting Started>