4.Operation Function Instruction
!INITIAL STATUS
●If you turn on this monitor, it search cameras.
●If all cameras weren't connected to monitor, this screen display channel 1.
@SEQUENTIAL SWITCHING MODE
●Please press AUTO button, the monitor goes to sequential switching mode and the yellow LED lamp of AUTO button will on.
●The sequential switcher built in the monitor allows each camera to show the pictures sequentially.
●If a camera is disconnected from the monitor, it will be skipped and the deep sounds.
●If camera 2 and camera 4 are connected to monitor, this is switched on sequence of camera 2, camera 4.
●If all cameras were disconnected to monitor in AUTO mode, monitor displays channel 1.
●The switching time can be adjusted from 1 to10 seconds by using time button.
●Initial dwell time is 2 seconds.
●If you want manually select camera, please press camera select button.
#ALARM FUNCTION
●When the alarm is triggered, its signal goes to the monitor and the monitor shows the triggered camera picture on the screen.
●When two or more cameras are triggered at the same time, the monitor shows finally triggered camera picture.
●To reset alarm in case of alarm triggering, press TALK(A.RESET) key.
●Once the alarm is released, the monitor goes back to the previous mode automatically.
●If you make the alarm off in the VCR mode, the system doesn't go back to the VCR mode. It goes back to more previous state than the VCR mode.
●To disable the alarm completely(the alarm is not detected), set alarm lamp off by using alarm button.
●Alarm time is 12 seconds.
$VCR MODE
● To see the recorded picture, press the VCR key on the system
%AUDIO SYSTEM
●This monitor has two way audio system.
●When a camera picture appears on the screen, you can hear the sound from the camera's microphone though the speaker built in the monitor.
●If you want to talk to camera 2, please select it and go on pressing TALK button and talk.
30