Samsung SW-224 manual Installing the CD-R/RW Drive, Connecting the Cables

SW-224_eng-02 12/19/01 4:42 PM Page 6

Installing the CD-R/RW Drive

To install your CD-R/RW drive in the PC, proceed as follows.

1 Make sure that the PC is powered off and disconnected from any power source.

2 If necessary, attach a horizontal bracket to both sides of the drive.

●Use of the brackets depends on your computer

model; you can purchase these accessories separately from your computer dealer.

3 Remove the cover from a free expansion slot and install the CD-R/RW drive, as shown in the illustration.

● If you have no free expansion slot, install the drive in place of the diskette drive.

CD-R/RW drive

Connecting the Cables

2 Installing a jumper on the master/slave select terminal

Install the jumper in the correct position on the terminal:

MA to use the device in the master mode

SL to use the device in the slave mode CS to control the device via a CSEL

host interface signal

See Step 3 for further details.

3 Connecting the E-IDE cable Two configurations are possible.

●The CD-R/RW drive is the only E-IDE device in addition to the hard disk.

E-IDE port

Mother board

CD-R/RW Hard disk

(SL) (MA)

Install the jumper in the SL position (Slave).

Connect the 40-pin flat E-IDE cable from the E-IDE port on the mother board, first to the CD-R/RW drive and then to the hard disk.

●You already have an additional E-IDE device installed in your computer.

Second E-IDE cable First E-IDE cable

1. Power cable

2. Master/slave select terminal

3. E-IDE cable

CD-R/RW CD-ROM

(MA) (SL)

Mother

board

Hard disk	Hard disk
(SL)	(MA)

4. Audio cable

1 Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the CD-R/RW drive.

Install the jumper in the MA position (Master).

Connect the 40-pin flat E-IDE cable from a second E-IDE port on the mother board directly to the CD-R/RW drive or first to another additional E-IDE drive and then to the CD-R/RW drive.

4 Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW drive and the audio input terminal on the sound card.

For clearer sound,use a digital output terminal. (Available only for the CAID that supports digital output) This may not be available for general sound cards.

6 7