Mitsubishi Electronics PD-5010 manual Mitsubishi Plasma Display Panel Limited Warranty

Page 66

MITSUBISHI PLASMA DISPLAY PANEL LIMITED WARRANTY

MITSUBISHI DIGITAL ELECTRONICS AMERICA, INC. (“MDEA”) warrants to the original purchaser of this Plasma Display Panel that if urchasedp from an authorized MITSUBISHI Audio/Video Dealer, should it prove defective by reason of improper workmanship and/or material:

a. Parts. All parts are warranted for a period of one year from the date of the original purchase at retail. We will repair or replace, at our option, any defective part without charge for the part. Parts used for replacement may be replaced with those of like kind and quality and may be new or remanufactured. Parts used for replacement are warranted for the remainder of the original warranty period.

b. Labor. We will provide the labor for a warranty repair by an authorized MITSUBISHI service center without charge for one year from the original date of purchase at retail.

c. Notice. To obtain warranty service, you must notify an authorized MITSUBISHI service center of any defect within the applicable warranty time period.

1. TO OBTAIN WARRANTY SERVICE:

a. Contact your nearest authorized MITSUBISHI service center, whose name and address can be obtained from your MITSUBISHI dealer or by writing or calling MDEA at the address and telephone number provided below.

b. Warranty service will be provided in your home or, if required, at an authorized MITSUBISHI service center, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. Actual service labor will be provided without charge.

c. Proof of purchase date from an authorized MITSUBISHI dealer is required when requesting warranty service. Present your sales receipt or other document which establishes proof and date of purchase. THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF WARRANTY COVERAGE. However, please return the Owner Registration Card so that we can contact you should a question of safety arise which could affect you.

3.This Plasma Display Panel uses a revolutionary technology, gas plasma, to create the screen image. This technology creates the image using small dots, or picture elements (pixels). Your Plasma Display Panel is manufactured to a high level of perfection, in fact, 99.99% of the total number of active pixels will operate properly. As in tube television, sometimes a pixel is continuously active or inactive. Our standard is clear, your pixels must be 99.99% operational at all times.

4.THIS WARRANTY DOES NOT COVER:

a. ............ Up to .01% pixel outages (small dot picture elements that are dark or incorrectly illuminated).

b. ............ Cosmetic damage or damage to this Plasma Display Panel or to any other products where such damage is caused by unauthorized

modification, alteration, repairs to or service of the product by anyone other than an authorized MITSUBISHI service center; physical abuse to or misuse of the product (including any failure to carry out any maintenance as described in the Owner’s Guide or any product damaged by excessive physical or electrical stress); any products that have had a serial number or any part thereof altered, defaced or removed; product use in any manner contrary to the Owner’s Guide (including, but not limited to, uneven phosphor aging and imprinted images on the viewing screen); freight damage or damage due to improper shipping methods; damage caused by use of third party mounting brackets or stands or any damage caused by acts of God or other factors beyond the reasonable control of MDEA, such as power surge damage caused by electrical system or lightning. This warranty also excludes service calls where no defect in the product covered under this warranty is found, service calls related to unsatisfactory audio or visual reception or signal unless caused by a defect in the product that is covered under this warranty, all costs, expenses or any other damages arising from product installation, or set-ups, any adjustments of user controls (including, contrast, brightness, color, tint, fine tuning, sharpness), other adjustment necessary to prepare the unit for display or use, connection with any external TV tuner, audio receiver, antenna, cable or satellite systems, or service of products purchased or serviced outside the U.S.A. Please consult the operating instructions contained in the Owner’s Guide furnished with the product for information regarding user controls.

5.ANY EXPRESS WARRANTY NOT PROVIDED HEREIN, AND ANY REMEDY WHICH, BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION OR OPERATION OF LAW, IS HEREBY EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF ONE YEAR.

6.UNDER NO CIRCUMSTANCES SHALL MDEA BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY, BREACH OF CONTRACT, OR OTHERWISE.

7.Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental, special or consequential damages, so the above limitations or exclusions may not apply to you.

8.This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

9.BEFORE REQUESTING SERVICE, please review the instruction booklet to insure proper installation and correct customer control adjustment. If the problem persists, contact your nearest MITSUBISHI Dealer for the name(s) of authorized MITSUBISHI Service Center(s). If you are unable to obtain this information, please call 800-332-2119, or write us at the address below.

MITSUBISHI DIGITAL ELECTRONICS AMERICA, INC.

9351 Jeronimo Road

Irvine, CA 92618-1904

60

Image 66
Contents Owner’s Guide Page Precautions Important InformationTo avoid damage and prolong operating life Contents Page Attachment Options for the PD-5010 Monitor Introduction Part Names and Function Rear View/ Terminal Board Remote Control Battery Installation and Replacement Using the wired remote control mode Installation Connecting Your PC or Macintosh Computer External Speaker Connections Pin Assignments and Signal Levels for 15 pin RGB Analog Basic Operations InformationAfter the power is turned off with the off timer To set the off timerTo cancel the off timer To check the remaining timeWide Operations Watching with a wide screen manualPicture Size setting When Picture Size is set to OFFInformation Supported resolution Watching computer imagesShowing a couple of pictures on the screen at the same time Operations in the Side-by-side modePIP Screen Operations InformationOperations in the Picture-in-picture mode Selecting the input signals to be displayedAdjusting the ON-SCREEN Menu controls On Screen Menu Controls Menu OperationsMain menu Sub menu Functions Default Information Video Settings screen Picture Settings MenuAdjusting the picture Adjusting the computer imageExample Setting the Theater mode Information Types of picture modesOnce the setting is completed Setting the color temperatureExample Setting LOW Information Setting the color temperatureAdjusting the color to the desired quality Example Adjusting the White BalanceInformation Adjusting the white balance Example Setting NR-3 Reducing noise in the pictureTypes of noise reduction Example Adjusting the bass Audio Settings MenuAdjusting the treble, bass and left/right balance Information Sound settings menuMonitor Settings Menu Example Adjusting the vertical position in the normal modeInformation When Auto Picture is OFF Setting the on-screen menu Example Turning the on-screen menu mode offFunction Menu To adjust the position Adjusting the position of the menu displayExample Adjusting the position of the menu display Information Adjusting the position of the menu displayInformation Power management function Setting the power management for computer imagesExampleTurning the power management function on Power management settingsPOWER/STANDBY indicator Example Adjusting the Gray Level Setting the gray level for the sides of the screenSetting the picture to suit the movie Example Setting the Cinema Mode to OFFInformation When you adjust the M-LINK ADJ Setting Monitorlink M-LINK ADJExample Setting Example Setting PLE to LockSetting the time for Inverse Peak Luminance Enhancement PLESetting the time for Screen Wiper Information Setting the timeTo select on for the Working Time Resetting to the default values SpeedSetting the BNC connectors Options Setting MenuSetting the allocation of the audio connectors Example Setting Audio 1 to VideoTo set the RGB select mode to Motion Setting a computer image to the correct RGB select screenExample Setting the RGB Select mode to Motion See page 55 for the details of the above settingsSetting high definition images to the suitable screen size Setting the picture size for RGB input signalsInformation HD Select modes Information Language settings Setting the language for the menusExample Setting the menu display to Deutsch Information MenuInformation Video signal formats Setting the video signal formatExample Setting the video signal format to 3.58 Ntsc To select 3.58 NtscConnections External ControlApplication Communication FormatPower OFF Command Reference ListPower on Input Switch ChangeAudio Mute Off Volume Gain DataAudio Mute On Contrast Gain DataPicture Mode Select Color Gain DataRED Gain Data Blue Gain Data NR Mode SetGreen Gain Data Bass Gain Data22. V. Position Gain Data Screen Mode SelectBalance Gain Data 23. H. Position Gain DataClock Gain Data Phase Gain DataAuto Picture Select Menu SelectMenu ADJ. Gain Data Power MGT SelectCinema Mode Set Gray Level SetInverse Set Screen Wiper SetAudio Select Set Picture Size Select RGB SelectHD Select Language SelectColor System Select Multi Screen SelectInput Mode Request Frequency RequestHorizontal sync polarity Video ADJ Request Failure Mode Request Audio Select RequestModel Name Request Table of Signals Supported Supported resolutionComputer input signals supported by this system Page Troubleshooting Symptom Checks RemedySpecifications SignalsPage Mitsubishi Plasma Display Panel Limited Warranty