JVC BD-X200E manual Alarm Messages

LCD Display and On-Screen Content

Alarm Messages

Alarm messages are displayed on the DVD recorder’s LCD display and on the monitor when the recorder cannot obey a command. These messages will remain on-screen until the next operation is carried out.

Monitor screen

000 min

	REC INHIBIT
		REC
04/05/04	TITLE 1 0:11:22
11:20:00	CHAPTER 1 0:11:22

Alarm messages: Displayed when DISPLAY from the

DISPLAY MENU screen is set to ON.

LCD display

DOLBY DIGITAL

LPCM MPEG

Alarm message

Monitor message	LCD display	Description
	message
INVALID DISC	INVALId dISC	The current disc is not a DVD-R or DVD-RW.
NOT SUPPORT	NoT SUPPoRT	A disc recorded using a different DVD recorder was inserted or played.
DISC
REC INHIBIT	REC INH	● Recording was attempted using a disc on which no more data can be recorded.
		● The current disc is a non-finalized DVD-RW to which no more data can be recorded.
COPY INHIBIT	CoPY INH	Recording of a copy-protected signal was attempted.
DISC FULL	dISC FULL	All remaining space on the disc is used up during recording.
CELL OVER	CELL oVER	The number of cells for a single title exceeded 255.
		This will be displayed when the recording time for a single title is exceeded as a
		result of setting ENCODE QUALITY to a low value (i.e., 4 Mbps or lower), recording
		content with little movement, or other similar factors. No error will be triggered when
		the time is within that set for the total content.
OVERHEATING!	oVERHEATING	Displayed when the internal temperature of the set rises due to fan malfunction, etc.
		In this case, immediately turn off the power and discontinue use. The power will
		automatically shut down in about 20 minutes after the OVERHEATING display.
————	ERRoR	This is displayed when playback or recording is stopped due to dirt or damage on the
		disc. In this case, either clean the disc or replace it.

CAUTION

If alarm messages such as “INVALID DISC” are displayed several times when a disc recorded using the BD-X200 or a blank disk is inserted, there is a possibility that the disc itself has been damaged. In such a case, the damaged disc should be replaced with a new one.

If the alarm messages continue to appear after replacing the disc, the problem may lie within the DVD recorder, and in such a case, you are recommended to contact either the store where this BD-X200 was purchased or your nearest JVC authorized dealer.

E-20