JVC BD-X200E manual Preparation, Signal Connections,  Audio and video signals

Preparation

Signal Connections

Audio and video signals

			Video outputs for VCR
				Note 1
			Input
		DV		Composite
Audio outputs for VCR			YC separate		Monitor or TV
	Note 2
Input
Analog audio DV					Composite

	Note 4				Note 3		Analog audio
DV IN/OUT	Y/C IN	LINE IN			LINE OUT
			VIDEO			AUDIO
		IN	LINE	OUT	INPUT		CH1
					LEVEL	IN	OUT
					4dB
					8dB		AUDIO OUT
		IN	Y/C

		CH2	Headphones
		REMOTE
		DV IN/OUT
DV IN/OUT	LAN SIGNAL	USB	PHONES
	GND	DC 19V	(on front panel) Stereo

AUDIO IN

同期信号発生器

Note 5

English

Note 1: The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.

Note 2: The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.

When either LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be selected for input.

When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.

Note 3: When the DVD recorder is in Stop or Recording mode, the video input signal is output on the E-E screen as a composite video signal.

In addition, the Setup Menu and other setting screens are also displayed on the monitor connected to this terminal. The DVD recorder’s operation status and other relevant information are displayed on-screen when DISPLAY from the DISPLAY MENU screen has been set to ON.

Note 4: The Y/C IN terminal’s specification (i.e., S1 or S2) can be selected using Y/C TERMINAL MODE from the RECORDER MENU (2/2) screen.

Note 5: The standard input level for audio signals input via the AUDIO IN terminals (i.e., +4 dB or –8 dB) can be selected using the AUDIO INPUT LEVEL switch on the rear panel.

E-21