JVC BD-X200E manual Power Connections, Connect the AC adaptor included to the DVD recorder

Power Connections

Connect the AC adaptor (included) to the DVD recorder.

			VIDEO		AUDIO
			IN LINE	OUT INPUT		CH1
				LEVEL	IN	OUT
					4dB
					8dB
			Y/C
			IN
						CH2
			DV IN/OUT		REMOTE
		LAN	SIGNAL	USB	DC 19V
			GND
	Power cord	AC adaptor
		(included)
	(included)
						DC IN
				Clamp
AC			Screw

English

OPERATEOPERATE indicator

AUDIO

CH1

CH2

PHONES REV

Note

A small amount of current will be required by the DVD recorder when in Operate Off mode.

1.Connect the AC adaptor’s DC cord to the DVD recorder’s DC IN terminal.

2.Secure the DC cord using the DC power cord clamp in order to prevent accidental disconnection.

q Remove the screw and then the clamp.

w Insert the DC cord into the clamp, and then secure the clamp to the DVD recorder.

3.Connect the power cord (included) to the AC adaptor’s AC IN terminal.

4.Insert the power cord into an electrical outlet.

●Power will be supplied to the DVD recorder and the OPERATE indicator will be lit up in red. (Operate Off mode)

CAUTION

●Always use the AC adaptor provided with the DVD recorder.

The use of other power sources should be avoided.

●Do not disconnect the DC cord or power cord during recording or playback.

In the case of DVD-R discs, failure to observe this precaution will result in the discs becoming unusable. In the case of DVD-RW discs, it will be necessary to erase all data from the disc and to start recording again from the beginning.

E-23