JVC LPT1029-001A Auto Set Up, Programme Number Set, Before starting, make sure of the following

SET UP ENTER SELECT WITH @ THEN PRESS [ENTER]

PRESS [SET UP] TO EXIT

EXIT SELECT

INITIAL SET UP > AUTO SET

		INITIAL SETTINGS EN 19
Auto Set Up		ATTENTION:
		AAUTOB blinks on the front display panel; do NOT press any button
Auto Channel Set/Auto Clock Set/Auto Guide		on the unit or remote control until the front display panel shows
		A– –:– –Bas illustrated on page 21.
Programme Number Set		● When you have connected the unit to a TV offering T-V Link via a
		fully-wired 21-pin SCART cable (A pg. 18) and the TV is turned
		on, the unit automatically performs the Preset Download
After the A button on the unit (or DVD A on the remote		(A pg. 20) even if you select AAUTO SETB for Auto Set Up
control) is pressed for the first time to turn on the unit, the Auto		function.
Set Up function sets the tuner channels, clock and Guide
Programme numbers automatically.		ATTENTION:
		Once you have performed Auto Set Up, even if the unit’s
		memory backup has expired, all the stored stations and their
		Guide Programme numbers remain in the unit’s memory and the
		unit will not perform Auto Set Up again. The unit only performs
		Auto Clock Set when the unit is turned on.
1		If you have moved to a different area, perform each setting as
		required.
CABLE/SAT		● Tuner setting (A pg. 75)
TV	DVD	● Clock setting (A pg. 78)
		If a new station starts broadcasting in your area, perform tuner
DVD A		setting. (A pg. 75)
		NOTES:
		● In areas where no TV station transmits a PDC (Programme
		Delivery Control) signal, the unit can perform neither Auto Clock
		Set nor Auto Guide Programme Number Set.
		● If there is a power cut, or if you press A or SET UP while Auto
ENTER		Set Up is in progress, Auto Set Up will be interrupted; be sure to
		turn off the unit power once and try again from step 1.
Selection Keys
FGDE		● Auto Clock Set may not function properly depending on the
		reception condition.
		After AAuto Set UpB is completed, perform AMonitor SetB on
		page 23.

Before starting, make sure of the following:

●The TV aerial cable should be connected to the unit.

●The unit’s mains power cord should be connected to a mains outlet.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1Press A on the unit or DVD A on the remote control to turn on the unit. The AUTO SET/T-V LINK display appears on the TV screen.

2Press selection keys to select AAUTO SETB, then press ENTER. The AUTO SET screen will appear.

●When AUTO SET is

completed, ASCAN	INITIAL SET UP > AUTO CH SET
COMPLETEDB appears on
the TV screen. Select
AOKB.		AUTO SET	T-V LINK

		AUTO SET
		PLEASE WAIT...
		CANCEL
SET UP	ENTER	SELECT WITH @ THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT
EXIT	SELECT