JVC LPT1029-001A manual Edit From a Camcorder, If the camcorder has no S-VIDEO output connector

64 EN EDITING

Edit From A Camcorder		● Slide the TV/CABLE/SAT/DVD switch to DVD.
You can use a camcorder as the source player and your unit as the		1 Make connections.
		A If the camcorder has no S-VIDEO output connector:
recording deck.
		^ connect the camcorder’s AUDIO/VIDEO OUT connectors to
A If the camcorder has no S-VIDEO output connector:		the unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors
		on the front panel.
		● When using a monaural camcorder, connect its AUDIO OUT
		connector to the [AUDIO-L] input connector on your unit.
		B If the camcorder has an S-VIDEO output connector:
		^ connect the camcorder’s AUDIO OUT and S-VIDEO OUT
Recorder	To [VIDEO/AUDIO	connectors to the unit’s [AUDIO] and [S-VIDEO] input
		connectors on the front panel.

((MONO) L/R)] input
	2		Press HDD or DVD to select the recording deck.
	3		Press PR +/– to select AF-1B.
		● Set AF-1 INPUTB to AVIDEOB for the [VIDEO] input connector, or
Audio/video cable			AS-VIDEOBfor the [S-VIDEO] input connector, depending on
			the connector being used. (A pg. 67)
(not supplied)	4
			Press REC MODE repeatedly to set the recording mode.

5 Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.

Player

AUDIO/VIDEO OUT

BIf the camcorder has an S-VIDEO output connector:

6Press R on the unit to start recording. Or while holding R, press I on the remote control. The dubbing starts.

7Press o on the unit, then stop playback on the camcorder.

NOTES:

●All necessary cables can be obtained from your dealer.

●Refer to the camcorder’s instruction manual for operating procedure.

●The quality of dubbed picture becomes poorer than that of the original.

Recorder	To [S-VIDEO] input	To
		[AUDIO]
		input
	S-video cable	Audio cable
	(not supplied)
		(not supplied)
	S-VIDEO OUT
	Player
	AUDIO OUT