24 EN SAT CONTROL SET
The following procedure is required if you receive satellite
Satellite Receiver Control Setting channels through a satellite receiver. Approximately 20 seconds before the VIDEO Plus+ timer programming (A pg. 47) or Manual
Satellite receiver
Timer programming (A pg. 49) starts, the unit sets its input mode to
Your unit | Satellite Controller | |
(supplied) | ||
| ||
| (suggested location) | |
| Transmitter | |
Satellite receiver |
|
Satellite Controller (supplied)
Installing Satellite Controller
1Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.
2Fix securely using the adhesive strip attached on the back of the Satellite Controller.
3Be sure to connect the unit’s
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4Connect the Satellite Controller to the [SAT CONTROL] connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.
●Turn on the unit.
●Turn on the TV and select the AV mode.
●Slide the TV/CABLE/SAT/DVD switch to DVD.
1Turn on the satellite receiver’s power.
2Press SET UP to access the Main Menu screen.
3Press selection keys to select AINITIAL SET UPB, then press
G.
To [SAT CONTROL]
To 
DECODER]
Back of unit
4Press selection keys to select ATUNER SETB, then press G.
5Press selection keys to select ASAT CONTROL SETB, then press ENTER.
6Press selection keys to select ABRANDB, then press ENTER.
DVD VIDEO SET UP HDD/DVD SET UP | FUNCTION SET UP | INITIAL SET UP | ||
TUNER SET |
| CLOCK SET |
|
|
| AUTO CH SET | MANUAL CH SET |
| |
| SAT CONTROL SET | GUIDE PROG SET |
| |
SET UP | ENTER | SELECT WITH @ THEN PRESS [ENTER] | ||
|
| PRESS [SET UP] TO EXIT |
| |
EXIT | SELECT |
|
|
|
CABLE/SAT
TV 
DVD
7Press selection keys to select the brand code from the list on page 25, then press ENTER.
●If the unit is in playback or recording mode, you cannot set the brand code.
8Press selection keys to select APROGRAMMEB, then press
ENTER.
9Press selection keys to select one of the channel positions on the satellite receiver, then press ENTER.
●You can select the channel position between 1 to 999.
ENTER
Selection Keys
FGDE
10 Press selection keys to select ATESTB, then press ENTER. The unit enters the Test mode.
INITIAL SET UP > SAT CONTROL SET
BRAND |
| 73 |
PROGRAMME | 12 | |
|
| TEST |
SET UP | ENTER | SELECT WITH @ THEN PRESS [ENTER] |
|
| PRESS [SET UP] TO EXIT |
EXIT | SELECT |
|
SET UP