JVC LPT1029-001A manual Connecting To a Satellite Receiver

Page 70

70 EN SYSTEM CONNECTIONS

Connecting To A Satellite Receiver

Connect the satellite receiver to the [L-2 IN/DECODER] connector, then connect the [L-1 IN/OUT] connector to the TV’s connector.

NOTES:

Set AL-2 SELECTB to AVIDEOB or AS-VIDEOB. (A pg. 67)

You can use the Automatic Satellite Programme Recording function (A pg. 51) with this connection. (HDD deck only)

To record a programme via the satellite receiver, select L-2 mode by pressing PR +/– so that AL-2Bappears on the front display panel.

For details, refer to the instruction manual of the satellite receiver.

Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS

These instructions enable you to connect your unit to a Dolby Digital Decoder or an amplifier with built-in DTS.

Outdoor unit

Aerial

Satellite cable

TV aerial cable

Satellite receiver

ANTENNA IN

ANTENNA OUT

Dolby Digital Decoder or amplifier with built-in DTS

Optical cable (not supplied)

To [DIGITAL AUDIO OUT (OPTICAL)]

To DIGITAL AUDIO input

Coaxial cable (not supplied)

To [DIGITAL AUDIO OUT (COAXIAL)]

TV

IMPORTANT

When you set AL-2 SELECTB to ASAT VIDEOB or ASAT S-VIDEOB(A pg. 67), it is possible to view a satellite broadcast with the TV set to its AV mode even if the unit is turned off. When the unit is in Stop mode or recording, press TV AV/VIDEO on the remote control to turn off the VIDEO lamp on the unit.

If you turn on the unit when the satellite receiver’s power is off, nothing appears on the TV screen. In this case, turn on the satellite receiver, or set the TV to its TV mode, or press TV AV/ VIDEO on the remote control to set the unit to the AV mode.

Rear of unit

Note for connection: Remove the protection cap from the optical cable.

1Connect the unit and a Dolby Digital Decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY DIGITAL/PCMB. (A pg. 71)

For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB. (A pg. 71)

CAUTIONS:

This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

When you can’t switch the audio channel of a bilingual programme

When the unit is connected with a digital audio device using an optional optical cable and ADIGITAL AUDIO OUTB is set to ADOLBY DIGITAL/PCMB, it is not possible to switch the audio channel of a bilingual programme recorded on a DVD-RAM or DVD-RW (VR mode) disc. In this case, perform the following steps using the remote control to switch ADIGITAL AUDIO OUTB from ADOLBY DIGITAL/PCMB to APCM ONLYB.

APress SET UP to access the Main Menu screen.

BPress selection keys to select ADVD VIDEO SET UPB, then press G.

CPress selection keys to select AAUDIO OUTPUTB, then press G.

DPress selection keys to select ADIGITAL AUDIO OUTB, then press ENTER.

EPress selection keys to select APCM ONLYB, then press ENTER. (A pg. 71)

FPress SET UP to complete the setting.

GPress AUDIO to select the desired audio channel.

Image 70
Contents DR-MH50S Safety Precautions Or remote control Failure to heed the following precautions may resultDamage to the unit, remote control or disc Do not place the unitSome Do’s And Don’ts On The Safe Use Of Equipment Above ALLEdit Original Information Edit Play List Information Remote Control FunctionsVideo Plus+ System Setup Playback With MP3/WMA/JPEG NavigationDVD-RAM Discs About DiscsRecordable/Playable Discs DVD-R/RW DiscsUnplayable Discs Discs For Playback OnlyRegion Number DVD-RAM Recording Medium And FormatFile Structure Of Discs DVD-RDVD Video Marks Placing a DiscLabel side Maintenance of discsCare And Handling Of Discs Recording sideDVD Button a pg Front ViewHDD Lamp HDD a pg DVD Lamp DVD a pg Rear View C D E F G HFront Display Panel Remote Control How To UseCheck Contents On-Screen Display When pressing REC Mode Appears for eight secondsWhen pressing R during recording PR.12Connected DV equipment information When capturing images from the external DV equipmentOn-Screen Display DV Dubbing Elapsed recording timeWhen your TV’s Scart ConnectorsTo connect to TV’s component video input connectors Connector acceptsProgramme Number Set Auto Set UpBefore starting, make sure of the following Set/Auto Guide Programme Number Set Preset DownloadAuto Channel Set by Downloading from TV/Auto Clock On The Front Display Panel Results Of Auto Set Up/Preset Download AppearingLink Functions Press selection keys to select Alanguage SETB, then press G LanguageMenu/Audio/Subtitle Language Set DVD deck only EnterPan&Scan Monitor SetPan&Scan/Letter Box Letter BoxInstalling Satellite Controller Following procedure is required if you receive satelliteBrand Name Code Basic Playback Still Picture/Frame-By-FramePlayback Playback FeaturesVariable Speed Search Locating The Start Point Of The Item Or Skip The ItemSkip Search Slow Motion Resume FunctionJump Search Angle Selection Marking Positions To Play Back Again LaterChecking The Time Information DVD-RAM/DVD-R/DVD-RWPlayback Control PBC Function Subtitle Selection Audio Language/Sound SelectionAudio Channel Selection One Touch ReplayBasic Operation On The On-screen Bar How To Access The On-screen BarContents of the on-screen bar during playback NavigationDVD-RAM/RW/R Repeat PlaybackAudio CD/Video CD/SVCD/JPEG/MP3 Locating The Beginning Of a Desired Selection Time SearchSelect this option when too much noise appears Simulated Surround Effect Setting The Progressive ModeAdjusting The Picture Quality Normally select this optionProgramme Playback Random Playback While stoppedTo Set Parental Lock For The First Time To Change The SettingsParental Lockthen press Enter To Temporarily Release Parental LockRecording Mode Basic RecordingWatch Another Programme While Recording On The Unit Recording FeaturesInstant Timer Recording ITR Elapsed Recording Time And Disc Remaining Time IndicationReceiving Stereo And Bilingual Programmes Free Rate FunctionSelection Of The Audio Channel To Be Recorded On a Disc Type of Broadcast BeingPause recording on HDD deck Memory PlaybackReceiving Stereo And Bilingual Programmes Watch Another Programme While Recording On The UnitStill Picture/Frame-By-Frame Playback Basic Playback Playback FeaturesSlow Motion 5x Speed Playback A15 MinbRecording/playback Status Display Live Memory PlaybackPress R or Live to stop Live Memory Playback Jump + Available only when pausedJump LiveResuming Playback HDD deck only RetroActive Recording HDD deck onlyAbout limitation on temporary recording Video Plus+ Timer ProgrammingPress the number keys For the HDD deck Weekly/Daily RecordingVPS/PDC Recording For the DVD deckSatellite Receiver Users Manual Timer ProgrammingRelief Recording Cancel And Change Programmes Check ProgrammesRecording HDD Deck OnlyLimitations of registration Library Database NavigationAbout registration of information EditScan For Beginning Of Title Edit Original InformationModify Index Delete Title Modify Title NameModify Category ENTER. aModify Chapter To modify the pointsEdit Scenes Edit Play List InformationCreate Play List Play ListMove Scenes Add scenesDelete Play List Delete ScenesScan For Title From Library Edit Library InformationRegister Disc Locating The Desired Group And Tracks Playback With MP3/WMA/JPEGNavigation Press NavigationHigh Speed Dubbing From HDD To DVD DubbingJust Dubbing From HDD To DVD Manual Dubbing From HDD To DVD Original Dubbing From DVD To HDDDV Dubbing Remote control switchActivated. When the DV device cannot be operated from Auto capture buttonExample Dubbing to an MD When you dub from DV equipment other than a CamcorderTo skip unwanted part of the source picture If the camcorder has an S-VIDEO output connector If the camcorder has no S-VIDEO output connectorEdit From a Camcorder When using your unit as the source player When using your unit as the recording deckOutput And L-1Input Setting Output/Input SetInput Setting Select SettingTo use a decoder connected to the L-2 IN/DECODER connector Remote Control 1/2/3/4 Code Switching Remote Control FunctionsTV Multi-Brand Remote Control Slide the TV/CABLE/SAT/DVD switch to CABLE/SAT Connecting To a Satellite Receiver Mode Set To record the main and sub language of Nicam audio You cannot use the resume functionTo record in Linear PCM format Select this to dub the main channelYou can change the brightness of the front display panel Scan Mode SetTo turn off superimposed indications Normally select thisGuide Programme Number Set System SetupGuide Programme Number Tuner Set Auto Channel SetDelete a Channel Manual Channel SetChange Station Channel Position ENTER.Set Stations a Fine-Tuning Channels Already StoredSet Stations B Just Clock Clock SetSelection keys to set Format a Disc DVD Deck Only Is impossible to restore themNever turn off the unit or disconnect the mains power cord Format a DVD-RAM DiscAfter finalising For DVD-R/RW Video mode discs Cancel The Finalisation Of a DVD-RW DiscFinalise a DVD-R/RW Disc To lock tray Help FunctionTray Lock DVD Deck Only To unlock trayPlayback DVD Deck Initialising DVD Deck OnlyGeneral Playback HDD DeckRecording HDD Deck Timer RecordingOther Problems For basic connectionDuring Live Memory playback, o has been pressed. a pg Timer recording has finished during Live Memory playbackOn-screen Message An invalid PlusCode number has been input. a pgTemperature Power requirementPower consumption Dimensions WxHxDLanguage Code List Country/Area Code List for Parental Lock EN Appendix TV Station And ID List Station NameTV Station Channel Number Guide Audio Language/Sound Selection Country/Area Code List for Parental LockSelect The Switching Interval Of The Slide Show Elapsed Recording Time IndicationDR-MH50S