Runco LS-10I Using Hdmi CEC Messages, CEC Commands Supported by the LS-10i, CEC Command List

External Control

The LS-10i accepts and can respond to CEC command messages from a disc player, satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the LS-10i can perform the following actions:

•Turn itself on and select the correct input when the source component initiates playback of a disc or recorded program.

•Turn the source component on when you switch to its corresponding input on the LS-10i.

•Turn the source component off when the LS-10i is turned off (unless the source component is in playback mode).

•Change its OSD language when a similar change is made at the source.

To use CEC, connect your CEC-compatible sources to the HDMI inputs on the LS-10i. Set the HDMI CEC option to On (refer to HDMI CEC on page 67). Additional steps may be needed to enable CEC at the source. Refer to the documentation for your source device for more information.

Table 6-4lists the CEC commands supported by the LS-10i.

Table 6-4. CEC Commands Supported by the LS-10i

Opcode	Value
Feature Abort	0x00
Image View On	0x04
Set Menu Language	0x32
Standby	0x36
User Control Pressed	0x44
User Control Released	0x45
Active Source	0x82
Give Physical Address	0x83
Report Physical Address	0x84
Request Active Source	0x85
Set Stream Path	0x86
Device Vendor ID	0x87
Vendor Command	0x89
Give Device Vendor ID	0x8C
Menu Request	0x8D
Menu Status	0x8E
Give Device Power Status	0x8F
Report Power Status	0x90
Get Menu Language	0x91

6.2

Using HDMI CEC Messages

CEC Command List

Runco LS-10i Installation/Operation Manual 87