Runco LS-10I operation manual You must enter a passcode to access the Save ISF

Operation

Memory: Select Memory from the Main menu, then press ENTER to recall image quality settings previously saved, or to save changed settings in any of four memory locations.

•Recall Memory: Select Recall Memory from the Memory menu to recall saved image quality settings. Unless you select Default (see below), this control affects all sources, not just the active source.

•Custom 1 and Custom 2 contain the factory default settings when the projector is initially turned on.

•When you recall the ISF Day or ISF Night memory settings, all settings associated with these stored values are grayed out. This prevents unintended adjustments from being made. To remove this restriction, choose Custom 1 or Custom 2.

ISF Day and ISF Night are grayed out unless these custom settings have already been saved.

•Choose Default to restore the factory-default settings for the active source only. The other sources are unaffected.

•Save Settings: Select Save Settings from the Memory menu to save any image-related settings you have changed to Custom 1 or Custom 2.

The following items are saved (for all sources, not just the active source):

•Brightness / Contrast

•Color / Tint

•Sharpness (all settings in sub-menu)

•Noise Reduction (all settings in sub-menu)

•Color Space

•Video Standard

•Gamma

•Color Temperature

•DLP Frame Rate

•Color Gamut and PCE settings

•ConstantContrast

•Adaptive Contrast

•RGB Adjust (all settings in sub-menu)

•Lamp Power

•Save ISF: Select Save ISF from the Memory menu to save any image-related settings you have changed to the ISF Day or ISF Night memory location.

You must enter a passcode to access the Save ISF

Note sub-menu.

The settings that are saved are the same as those saved with the Save Settings command (see above).

50 Runco LS-10i Installation/Operation Manual