Runco LS-10I operation manual OSD menus are not available when in test pattern mode

Operation

Lamp Hour Reset: When you replace the projector lamp (refer to Lamp Replacement on page 71), you should also reset the lamp hour counter. To do this, select Lamp Hour Reset from the Service menu, then press ENTER. Press ENTER again to confirm the reset. Or, to cancel the operation, press on the remote to highlight No, then press

ENTER.

Note

WARNING

Reset the Lamp Hour counter ONLY after you replace the lamp. Otherwise, the reported “Lamp Hours” will be inaccurate.

Do not exceed the recommended lamp life. An old lamp becomes increasingly fragile and prone to sudden failure.

Factory Reset: Select Factory Reset from the Service menu to restore all projector settings – except those listed below – to their factory-default values:

•Lamp Hours

•Custom 1 / Custom 2

•ISF Day

•ISF Night

•Model Name / Serial Number

•Language

Blue Only: This feature removes all red and green color information from the image, and is useful for color-calibrating the projector or other video components.

Test Patterns: The LS-10i has numerous internal test patterns that are useful to technicians for advanced calibration, measurement and fault isolation purposes. To access them, select Test Patterns from the Service menu and set it to On.

The available test patterns are:

•White

•Black

•Red

•Green

•Blue

•Cyan

•Magenta

•Yellow

•ANSI Checkerboard

•Horizontal Gray Ramp

•Focus Grid

Press or on the remote control unit or built-in keypad to cycle through the test patterns.

The OSD menus are not available when in “test pattern” mode.

Note

Runco LS-10i Installation/Operation Manual 69