Runco LS-10I operation manual LS-10i Control Menu

Operation

Control ➤ Select Control from the Main Menu to set various options related to control of the projector.

Figure 4-17. LS-10i Control Menu

Lens Control: Select Lens Control from the Control menu to perform lens adjustments (focus, zoom and lens shift). For detailed instructions, refer to Primary Lens Adjustments on page 38.

HD 1 Key / HD 2 Key / HD 3 Key: These menu items assign the function of the HD 1,

HD 2 and HD 3 buttons on the remote.

There are eight sources corresponding to the eight connections to the projector. When you assign a source to the HD 1, HD 2 or HD 3 button, the projector immediately goes to that source when the button is pressed.

If the chosen source is disabled via the Input Enable menu (refer to page 63), this setting has no effect.

You can also assign one or more of these buttons to the PIP function. When you do, the projector switches to the next available “PIP Select“ state each time the button is pressed. Refer to PIP Select on page 54 for more information.

CineWide: Select CineWide from the Control menu and set it according to the installed lens configuration, as follows:

•For a standard LS-10i (no anamorphic lens), choose Off.

•For an LS-10i with a fixed anamorphic lens, choose CineWide.

•For an LS-10i with a motorized anamorphic lens, choose AutoScope.

66 Runco LS-10i Installation/Operation Manual