TacT Audio RCS 2.0S owner manual Optional DAC module, Analog Output Section Microphone input

Page 11

	RCS 2.0S Connections
Analog Output	The RCS 2.0S has 2 stereo analog outputs when the optional DAC module is
(optional DAC module)	installed:
	- one analog stereo single ended (RCA)
	- one analog stereo balanced (XLR)

Analog Output Section

Microphone input

Connect the supplied measurement microphone to the “Mic Input” connector when taking a room measurement for room correction.

CAUTION: To avoid damage through static discharge, we strongly recommend to turn off the RCS 2.0S at the rear panel mains switch before connecting the microphone.

Microphone Input

Tact Audio 11

Image 11

Contents RCS 2.0S Blank Tact Audio Page Registration AcknowledgmentsTable of contents Unpacking the RCS 2.0S Accessories Operating voltageIntroduction Digital Output Section Tact Audio RCS 2.0S ConnectionsDigital input Digital Output Digital Input SectionAnalog Input RCS 2.0S Connections Optional ModulesMicrophone Input Tact Audio Analog OutputOptional DAC module Analog Output Section Microphone inputRS-232 Interface Ports AC mains input Tact Audio AC mains input & mains switchRCS 2.0S Connections RS-232 interface PortsMenu Front Panel ControlsStandby Input selector Remote Control Correction block Volume BlockFront Panel Display Correction preset selectionEQ preset selection Input sampling frequency indicatorSaving Menu SettingsDelay menu Assigned to each input independently Right for each room correction preset including bypassUP and Down buttons to change its value Test menu Displ menuAnd/or daisy chain RS232 ports to link multiple components Selection before the AMP setting will be enabledAddr menu REM menuPreset Link N Link Y EQ L Parametric EQ LEV OCTTer Tact Audio Front Panel Display Tone menuFrequency and Octave Info menu OFS menuYour computer system must meet the following requirements TacT 2.0S Room Correction SoftwareConnection at this time Connect yourRCS-2.0 S to your ComputerTact Audio Blank Before You Begin Quick SetupStep Quick Setup Getting StartedQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware Default Settings window Update the RCS 2.0S Firmware StepRestoring the Default RCS 2.0S SettingsBlank Tact Audio TacT Audio, Inc