TacT Audio Update the RCS 2.0S Firmware Step, Restoring the Default, RCS 2.0S Settings

Page 36

Update the RCS 2.0S Firmware

Step V:	This step is optional and is only required if you would like to reset all
Restoring the Default	internal settings in the unit to their factory defaults. If you proceed
RCS 2.0S Settings	you will erase your custom user settings.
	Restore the default settings for the new firmware installed on the RCS 2.0S.
	1- From the RCS 2.0S correction software main screen, click on the “Options”
	menu selection and select the “Default Settings” option. You should now see the
	Default Settings window.

RCS 2.0S update complete

2- Select the “Default” button and the default parameters for the RCS 2.0S will be loaded into the RCS 2.0S. The RCS 2.0S will turn OFF and the ON and return to normal operation.

NOTE: If you have TacT digital amplifiers attached to the RCS 2.0S you must set the “AMP” settings to “DISABLED”. The default settings will not be programed if these parameters are set to “ENABLED”.

You have now completed updating your RCS 2.0S and it is ready for normal operation.

36 Tact Audio

Image 36

Contents RCS 2.0S Blank Tact Audio Page Acknowledgments RegistrationTable of contents Accessories Operating voltage Unpacking the RCS 2.0SIntroduction RCS 2.0S Connections Digital input Digital OutputDigital Input Section Digital Output Section Tact AudioRCS 2.0S Connections Optional Modules Analog InputAnalog Output Optional DAC moduleAnalog Output Section Microphone input Microphone Input Tact AudioTact Audio AC mains input & mains switch RCS 2.0S Connections RS-232 interfacePorts RS-232 Interface Ports AC mains inputFront Panel Controls Standby Input selectorMenu Remote Control Volume Block Correction blockCorrection preset selection EQ preset selectionInput sampling frequency indicator Front Panel DisplaySettings Delay menuSaving Menu Right for each room correction preset including bypass UP and Down buttons to change its valueAssigned to each input independently Displ menu Test menuSelection before the AMP setting will be enabled And/or daisy chain RS232 ports to link multiple componentsREM menu Addr menuPreset Link N Link Y EQ L LEV OCT Parametric EQFront Panel Display Tone menu Frequency and OctaveTer Tact Audio OFS menu Info menuTacT 2.0S Room Correction Software Your computer system must meet the following requirementsConnect your RCS-2.0 S to yourComputer Connection at this timeTact Audio Blank Quick Setup Before You BeginQuick Setup Getting Started StepQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware Update the RCS 2.0S Firmware Step Restoring the DefaultRCS 2.0S Settings Default Settings windowBlank Tact Audio TacT Audio, Inc