TacT Audio RCS 2.0S owner manual Quick Setup Getting Started, Step

Page 30

Quick Setup
	Getting Started	Start the Quick Setup by selecting the yellow “Quick Setup” button located on the
		Tact 2.0 S Room Correction software’s main window.
		The Tact 2.0S Quick Setup wizard is broken into three steps. As you complete
		each step select the “NEXT” button proceed to the next step.
	STEP I	Set the Loudspeaker Lower Cutoff frequency. Your main loudspeaker
		frequency response will determine the setting needed for this parameter. Please
		refer to your main loudspeaker manual for this information.

-Loudspeaker lower cutoff frequency (this is the lowest frequency that your loudspeakers can reproduce)

STEP II

Do you have one or more M/S 2150 digital amplifier connected to your RCS 2.0S?

30 Tact Audio

-If you do not use Tact digital amplifiers select “No”. Then select the “Next” button and go to Step III.

Image 30

Contents RCS 2.0S Blank Tact Audio Page Acknowledgments RegistrationTable of contents Accessories Operating voltage Unpacking the RCS 2.0SIntroduction Digital Input Section RCS 2.0S ConnectionsDigital input Digital Output Digital Output Section Tact AudioRCS 2.0S Connections Optional Modules Analog InputAnalog Output Section Microphone input Analog OutputOptional DAC module Microphone Input Tact AudioPorts Tact Audio AC mains input & mains switchRCS 2.0S Connections RS-232 interface RS-232 Interface Ports AC mains inputFront Panel Controls Standby Input selectorMenu Remote Control Volume Block Correction blockInput sampling frequency indicator Correction preset selectionEQ preset selection Front Panel DisplaySettings Delay menuSaving Menu Right for each room correction preset including bypass UP and Down buttons to change its valueAssigned to each input independently Displ menu Test menuSelection before the AMP setting will be enabled And/or daisy chain RS232 ports to link multiple componentsREM menu Addr menuPreset Link N Link Y EQ L LEV OCT Parametric EQFront Panel Display Tone menu Frequency and OctaveTer Tact Audio OFS menu Info menuTacT 2.0S Room Correction Software Your computer system must meet the following requirementsComputer Connect yourRCS-2.0 S to your Connection at this timeTact Audio Blank Quick Setup Before You BeginQuick Setup Getting Started StepQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware RCS 2.0S Settings Update the RCS 2.0S Firmware StepRestoring the Default Default Settings windowBlank Tact Audio TacT Audio, Inc