TacT Audio RCS 2.0S owner manual Remote Control

Page 14

14 Tact Audio

Remote Control

The remote control is used to access the front panel display controls and menus.

1				2

3

4														5
4
7


														6
														6
															10
9
9
11													8
11
12

Image 14

Contents RCS 2.0S Blank Tact Audio Page Acknowledgments RegistrationTable of contents Accessories Operating voltage Unpacking the RCS 2.0SIntroduction Digital Input Section RCS 2.0S ConnectionsDigital input Digital Output Digital Output Section Tact AudioRCS 2.0S Connections Optional Modules Analog InputAnalog Output Section Microphone input Analog OutputOptional DAC module Microphone Input Tact AudioPorts Tact Audio AC mains input & mains switchRCS 2.0S Connections RS-232 interface RS-232 Interface Ports AC mains inputMenu Front Panel ControlsStandby Input selector Remote Control Volume Block Correction blockInput sampling frequency indicator Correction preset selectionEQ preset selection Front Panel DisplaySaving Menu SettingsDelay menu Assigned to each input independently Right for each room correction preset including bypassUP and Down buttons to change its value Displ menu Test menuSelection before the AMP setting will be enabled And/or daisy chain RS232 ports to link multiple componentsREM menu Addr menuPreset Link N Link Y EQ L LEV OCT Parametric EQTer Tact Audio Front Panel Display Tone menuFrequency and Octave OFS menu Info menuTacT 2.0S Room Correction Software Your computer system must meet the following requirementsComputer Connect yourRCS-2.0 S to your Connection at this timeTact Audio Blank Quick Setup Before You BeginQuick Setup Getting Started StepQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware RCS 2.0S Settings Update the RCS 2.0S Firmware StepRestoring the Default Default Settings windowBlank Tact Audio TacT Audio, Inc