Remote Control
1 - STANDBY
The STANDBY button will turn the RCS 2.0S on or it will place it into standby mode. When in stand by mode, the unit is placed into a low power “idling” state. The standby button is also used to save changes that were made in the menu parameters. By placing the unit into standby mode the current menu settings are saved.
2 - DIGITAL
The DIGITAL button will scroll sequentially, allowing the selection one of the 5 digital inputs.
3 - ANALOG
The ANALOG button will scroll sequentially, selecting one of 4 analog inputs. allowing the selection one of the
4 - CORRECTION block
The CORRECTION block consists of 10 buttons. The buttons are numbered from 1 to 9 and one BYPASS. Pressing the BYPASS button will place room correction into bypass mode – no correction applied. Pressing any of the remaining nine buttons will engage the corresponding room correction preset.
5 - MENU
The MENU button will switch the front panel display from the status screen to the main menu screen.
6. VIDEO
The VIDEO button is inactive with this unit.
7. UP
The UP navigational button is used to select menu options and/or change their values.
8. DOWN
The DOWN navigational button is used to select menu options and/or change their values.
9. LEFT
The LEFT navigational button is used to select menu options and/or change their values.
10. RIGHT
The RIGHT navigational button is used to select menu options and/or change their values.
11. ENTER
The ENTER button will select the menu option currently marked by the blinking cursor or is used to enter an edited parameter.
12. VOLUME Block
The VOLUME block consists of three buttons.
The “MUTE” button will
The “UP” button will increase the master volume level
The “Down” button will decrease the master volume level.