TacT Audio RCS 2.0S owner manual Automation

Page 32

Quick Setup

STEP III	Verify that the selections you made are correct and start the Quick Setup
	automation.

32 Tact Audio

-If the settings listed are not correct select the “Back” button to go back and make the appropriate changes and return to the finish screen when you are ready to start the Quick Setup.

-If the settings listed are correct select the “Finish” button. This will start the Quick Setup measurement and programing automation. When the automated process is completed the “Quick Setup Completed” message will be displayed. You can now close the RCS 2.0S software and audition your nine correction presets.

NOTE: The Quick Setup will give you a 15 second delay before the Quick Setup automation starts. This gives you time to leave the listening area before the measurement process begins.

Image 32

Contents RCS 2.0S Blank Tact Audio Page Acknowledgments RegistrationTable of contents Accessories Operating voltage Unpacking the RCS 2.0SIntroduction RCS 2.0S Connections Digital input Digital OutputDigital Input Section Digital Output Section Tact AudioRCS 2.0S Connections Optional Modules Analog InputAnalog Output Optional DAC moduleAnalog Output Section Microphone input Microphone Input Tact AudioTact Audio AC mains input & mains switch RCS 2.0S Connections RS-232 interfacePorts RS-232 Interface Ports AC mains inputMenu Front Panel ControlsStandby Input selector Remote Control Volume Block Correction blockCorrection preset selection EQ preset selectionInput sampling frequency indicator Front Panel DisplaySaving Menu SettingsDelay menu Assigned to each input independently Right for each room correction preset including bypassUP and Down buttons to change its value Displ menu Test menuSelection before the AMP setting will be enabled And/or daisy chain RS232 ports to link multiple componentsREM menu Addr menuPreset Link N Link Y EQ L LEV OCT Parametric EQTer Tact Audio Front Panel Display Tone menuFrequency and Octave OFS menu Info menuTacT 2.0S Room Correction Software Your computer system must meet the following requirementsConnect your RCS-2.0 S to yourComputer Connection at this timeTact Audio Blank Quick Setup Before You BeginQuick Setup Getting Started StepQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware Update the RCS 2.0S Firmware Step Restoring the DefaultRCS 2.0S Settings Default Settings windowBlank Tact Audio TacT Audio, Inc