TacT Audio owner manual Update the RCS 2.0S Firmware

Page 35

	Update the RCS 2.0S Firmware
Step IV:	After updating the firmware the System Files now need to be reprogrammed.

Reprogram the

RCS 2.0S System Files

1

1 - From the RCS 2.0S software main screen, click on the “Program TacT-2.0 S” button. You should now see the programming window.

2 - Press and hold the “Control” key on your computer keyboard and then press the “S” key simultaneously. This should display the System Option (1) in the bottom center of the programming window.

3 - Left click your mouse in the square next to System to select it with a check mark.

4 - Press the “Program” button and follow the prompts by answering all questions. You will need to be able to answer “Yes” to all questions to start the system file reprogramming. The Program window will display a “programming complete” message when the system is completed.

Tact Audio 35

Image 35

Contents RCS 2.0S Blank Tact Audio Page Registration AcknowledgmentsTable of contents Unpacking the RCS 2.0S Accessories Operating voltageIntroduction Digital Output Section Tact Audio RCS 2.0S ConnectionsDigital input Digital Output Digital Input SectionAnalog Input RCS 2.0S Connections Optional ModulesMicrophone Input Tact Audio Analog OutputOptional DAC module Analog Output Section Microphone inputRS-232 Interface Ports AC mains input Tact Audio AC mains input & mains switchRCS 2.0S Connections RS-232 interface PortsMenu Front Panel ControlsStandby Input selector Remote Control Correction block Volume BlockFront Panel Display Correction preset selectionEQ preset selection Input sampling frequency indicatorSaving Menu SettingsDelay menu Assigned to each input independently Right for each room correction preset including bypassUP and Down buttons to change its value Test menu Displ menuAnd/or daisy chain RS232 ports to link multiple components Selection before the AMP setting will be enabledAddr menu REM menuPreset Link N Link Y EQ L Parametric EQ LEV OCTTer Tact Audio Front Panel Display Tone menuFrequency and Octave Info menu OFS menuYour computer system must meet the following requirements TacT 2.0S Room Correction SoftwareConnection at this time Connect yourRCS-2.0 S to your ComputerTact Audio Blank Before You Begin Quick SetupStep Quick Setup Getting StartedQuick Setup Automation Update the RCS 2.0S Firmware Tact-2.0 S Programing Mode Update the RCS 2.0S Firmware Default Settings window Update the RCS 2.0S Firmware StepRestoring the Default RCS 2.0S SettingsBlank Tact Audio TacT Audio, Inc