TV SETUP OPERATION
How to use the On-Screen Display (OSD) system
With the
Basic Operation
MENU
1.Press 
button on the remote control or Menu button on the control panel of the unit. The Main Menu is displayed on the screen as shown on the right.
2.To select the item, press 
button.
The selected item will be highlighted in Yellow.
3.Press OK button to set your selection.
The selected menu page will be displayed on the screen.
Menu button
4.Use 
button to choose the item on the MENU page. Press OK button to set your selection.
5.Use 
button to adjust the item values or choose options.
Picture
Audio
Timer
Function
Setup
Language
Select OK Set
<Main Menu>
SD MEMORY
CARD
P
P
Press OK button to set your selection.
MENU
6.To exit from the menu, press 
button.
NOTE
The OSD menu screen will be closed automatically when no operation has been made for about one minute.
If the item in menu is shown in grey, it means that it cannot be selected or adjusted.
There is another main menu for DTT setting as shown. Refer to 40 about DTT main menu. (9700 models only)
OK
Menu button
PH35814
Main Menu
Channel List
Installation
Configuration
Timers
Language
TV Setup
Common Interface
<DTT Main Menu>
Language Menu
Select the language from the list so that you can display the OSD menu in the selected language.
How to set Language
1.Enter the “Language” menu from the Main Menu.
2.Select the appropriate language with cursor from the list. The selected item will be highlighted in Yellow.
3.Press OK button to set your selection.
The black dot is marked inside of the circle when the selection is fixed.
MENU
4.Press 
button to exit from the entire OSD menu.
NOTE
This setting is for Analogue OSD language.
As for the DTT OSD language, refer to "System language" on 41 . (9700 models only)
24
Language
English Svenska Norsk Suomi Dansk Česky Polski Magyar Slovenski Hrvatski
Select OK Set | Return |
For 32/37LD9700U/N
Language
English
Français
Deutsch
Italiano
Español Nederlands Eλληνικά Τϋrkçe Português Română
Select OK Set | Return |
For 32/37LD9700C
*The Analogue OSD language for 9600 models will be one of the two options shown depending on country.