Introduction
Before using the remote control
Load the 2 “AA” batteries into the remote control unit.
1.Slide the lid in the direction of the arrow.
2. Install 2 “AA” batteries as indicated inside the battery compartment.
3. Replace the lid and snap it into place.
Battery replacement caution
!Do not mix old and new batteries. (Also never mix alkaline with manganese batteries)
Note: Do not place the remote control unit upside down, otherwise the mouse button may be pressed down, which will cause the battery power to be consumed.
Remote control unit operating range
When using the remote control unit, point it at the front or rear of the LCD projector or at the projection screen. The range for optimum operation is within 30 degrees of the receiver at a maximum distance of about 23 feet (7m).
Remote control unit light up
Press the LIGHT button to illuminate the function buttons on the remote control unit for 10 seconds. The light goes out while any button is pressed, and then turns back on for an additional 10 seconds when the button is released.
14Polaview 215E LCD Projector User’s Guide