Polaroid 215EPolaview manual Replace the lamp

Appendix

Lamp Replacement Warning: If Status Code “L-n” (see page 62) is displayed on the Status Code Display when lamp is not turned on, take the LCD Projector to your nearest Service Center for repair as there is danger of injury due to lamp fragments.

Lamp replacement period

The LCD projector lamp has a limited operating life of approximately 1100 hours.

“LAMP TIME REMAINING 10h” will be displayed on screen when the operation time reaches 1090 hours. Then, each time the power is turned on, the lamp life remaining will be displayed.

A 10-second warning display (15 seconds when the LCD projector power is turned on) will appear every hour after 1090 hours of operation time, and the warning will flash during the last 5 minutes of lamp life.

LAMP TIME REMAINING	LAMP TIME REMAINING	LAMP TIME REMAINING
10h	9h		5min

LAMP TIME REMAINING 0min

If lamp use reaches 1100 hours

The LCD projector will shut itself off and the STATUS CODE indication will become “L-0”. (See STATUS CODE on page 62.)

Lamp Time Reset

Unless you change to a new lamp. POWER will be off 10 minutes later. Have you finished yet?

NO YES

1.Replace the lamp.

SELECT : PUSH C or V

2.Press POWER ON, the “Lamp Time Reset” display will appear to reset the lamp time.

•Only this screen will be displayed when POWER is pressed until the lamp time is reset. (The LCD projector cannot display a normal picture at this time.)

•If the lamp time is not reset, this screen will disappear and the LCD projector will shut itself off after about 10 minutes.

3.Press C or V to select YES.

4.Turn the power off to reset the lamp time.

English 65