Polaroid 215EPolaview manual Setting up the LCD projector

Page 19

Getting started

Setting up the LCD projector

Place the LCD projector on a stable, ﬂat surface according to the LCD projector/ screen relative position chart on page 32.

Positioning the LCD projector

Caution: Depending on the relative position of the LCD projector and the screen, improper adjustments may cause picture distortion. To prevent the LCD from wobbling, make sure both adjusters (see below) are in ﬁrm contact with the support surface.

Side view

projected image

center

center

screen

center the projected image on the screen

Original picture position

Picture position after adjustment

Front view

adjusters

To raise the projector, turn the adjusters to the right.

To lower the projector, turn the adjusters to the left.

Note: For a distortion-free picture, it is very important that the LCD projector be positioned so that it is perfectly horizontal. If necessary, turn the adjusters in either direction to make ﬁne adjustments.

18Polaview 215E LCD Projector User’s Guide

Image 19

Contents Polaview215E Table of contents Polview 215E LCD Projector User’s Guide Appendix Polview 215E LCD Projector User’s Guide General information Declaration of Conformity Important safeguards General information General information Introduction LCD projector featuresVideo board Contents of the LCD projector box Remote control unit Parts list and accessoriesBefore using the remote control LCD projector LCD projector back Bottom Click 2 button Pointer button Mouse button Click 1 button How to use the remote control unitSetting up the LCD projector Adjusting the lens Chart. see Connecting the LCD projectorConnecting to a Computer RGB signalVCR Computer cables & adapters VGA Pin assignmentsSwitches Setting the DIPRS-232C connector D-Sub25-pin RS-232C connector Mini DIN 8-pinFactory preset timing Vertical frequency 85.080 Hz 72.8088 Hz 75.0000 Hz Vertical frequency 72.188 Hz 75.000 Hz 85.061 Hz Preset timing *Compression Power Turning the power on and offPositioning the LCD projector and screen Set the Main power switch on the LCD projector to OFFLCD projector/screen relative position Basic LCD projector operation Turn on the powerInput signal Input signal format Using other useful functions Input Disp SET UP Projector Disabling the Power button on the remote control unitFunction CancelingEnlarging scanning Line conversionMinutes before Power is shut off Adjustment Adjusting the projected imageInput image Settings Adjustments for input imageRecall standard RGB sync adjustment Posi Horizontal Position Control Adjustments for RGB inputPhase Control Posi Vertical Position ControlPC Output Timing Relative Value Chart Adjusting the white balance Memory Projecting PC-Card ATA Flash Card data Press C or V to select an image When usingRepeat Play Jpeg Viewer installation Jpeg Viewer featuresType in A\SETUP.EXE and click OK Insert the PC-Card ATA Flash Card not supplied into Turn on the PC and start upFollowing are the software’s menu items and their functions Select the PC-Card drive for saving images ﬁle name numbers are renewed automatically Select the image that you want to delete Windows 95 / Windows ProMouse Control FeatureProMouse installation Using the ProMouse Software How to program Turn on the Macintosh Easy InstallCustom Install MacintoshSelect the Printer port or Modem port. Then click OK Select the Option Connection SettingApple Menu How to program Appendix MaintenancePlace the LCD projector up on its side as illustrated Set the Main power switch to OFF and unplug the power cordRemove the air filter unit Clean the filterReplace the air filter unit Replace the lamp Order Lamp 630146 Tools required a coin Remove the lamp unit screw Install the new lamp unitReplace the lamp unit screws Lamp Time Reset Before Requesting Service Specifications FCC, UL, C-UL, CE, VDE Polaroid Three Year Limited Warranty Polaroid Offices and Service Centers Norge