Enterasys Networks 5H102-48, 5H103-48 manual Installation, Unpacking the Module

Page 25

3

Installation

ELECTRICAL HAZARD: Only qualified personnel should install the module.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions to install the 5H102-48 or 5H103-48 module. A Phillips screwdriver is required to install options into the module. Follow the order of the sections listed below to correctly install the module.

•Unpacking the Module (Section 3.1)

•Installing the Module into the 5C105 MATRIX E5 Chassis (Section 3.2)

•Connecting to the Network (Section 3.3)

•Completing the Installation (Section 3.4)

3.1UNPACKING THE MODULE

Unpack the module as follows:

Installation 3-1

Image 25

Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Iii Enterasys NETWORKS, INC Program License AgreementPage Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents Guide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction5H102-48 and 5H103-48 Modules HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION ConnectivityPort Trunking Remote Monitoring RmonFlow Control PORT/VLAN Redirect Function802.1 Port Priority ManagementStandards Compatibility Switching OptionsPage Network Requirements Port Trunking Feature10BASE-T Network 100BASE-TX Network Unpacking the Module InstallationQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting UTP Cables to the 5H102-48 Connecting to the NetworkConnecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview TroubleshootingLanview LEDs both modules CPU Is enabled and there is a OFF Troubleshooting ChecklistLocal Management User’s Guide for the IP Reset Button both modules Using the Reset ButtonPage Module Specifications SpecificationsPhysical Properties Environmental RequirementsCOM Port Pinout Assignments INPUT/OUTPUT PortsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Page Numerics IndexIndex-2