Enterasys Networks 5H102-48, 5H103-48 Document Conventions, Guide uses the following conventions

Page 15

Document Conventions

DOCUMENT CONVENTIONS

The guide uses the following conventions:

NOTE: Calls the reader’s attention to any item of information that may be of special importance.

TIP: Conveys helpful hints concerning procedures or actions.

CAUTION: Contains information essential to avoid damage to the equipment.

ELECTRICAL HAZARD: Warns against an action that could result in personal injury or death due to an electrical hazard.

WARNING: Warns against an action that could result in personal injury or death.

xiii

Image 15
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Iii Enterasys NETWORKS, INC Program License AgreementPage Declaration of Conformity Page Contents Troubleshooting Figures Tables Using this Guide About This GuideStructure of this Guide Related Documents Guide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction5H102-48 and 5H103-48 Modules Remote Monitoring Rmon ConnectivityHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Port TrunkingManagement PORT/VLAN Redirect FunctionFlow Control 802.1 Port PriorityStandards Compatibility Switching OptionsPage Port Trunking Feature Network Requirements10BASE-T Network 100BASE-TX Network Unpacking the Module InstallationQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting UTP Cables to the 5H102-48 Connecting to the NetworkConnecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview TroubleshootingLanview LEDs both modules CPU Is enabled and there is a OFF Troubleshooting ChecklistLocal Management User’s Guide for the IP Reset Button both modules Using the Reset ButtonPage Environmental Requirements SpecificationsModule Specifications Physical PropertiesCOM Port Pinout Assignments INPUT/OUTPUT PortsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Page Numerics IndexIndex-2