Enterasys Networks 5H103-48, 5H102-48 manual

Page 6

5.UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was developed solely at private expense; (ii) contains “restricted computer software” submitted with restricted rights in accordance with section 52.227-19 (a) through (d) of the Commercial Computer Software-Restricted Rights Clause and its successors, and (iii) in all respects is proprietary data belonging to Enterasys and/or its suppliers. For Department of Defense units, the Product is considered commercial computer software in accordance with DFARS section 227.7202-3 and its successors, and use, duplication, or disclosure by the Government is subject to restrictions set forth herein.

6.EXCLUSION OF WARRANTY. Except as may be specifically provided by Enterasys in writing, Enterasys makes no warranty, expressed or implied, concerning the Program (including its documentation and media).

ENTERASYS DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY ENTERASYS IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

7.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL ENTERASYS OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS ENTERASYS PRODUCT, EVEN IF ENTERASYS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR IN THE DURATION OR LIMITATION OF IMPLIED WARRANTIES IN SOME INSTANCES, THE ABOVE LIMITATION AND EXCLUSIONS MAY NOT APPLY TO YOU.

iv

Image 6
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement IiiPage Declaration of Conformity Page Contents Troubleshooting Figures Tables Using this Guide About This GuideStructure of this Guide Related Documents Document Conventions Guide uses the following conventionsGetting Help Your email addressIntroduction Introduction5H102-48 and 5H103-48 Modules Port Trunking ConnectivityHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Remote Monitoring Rmon802.1 Port Priority PORT/VLAN Redirect FunctionFlow Control ManagementSwitching Options Standards CompatibilityPage Port Trunking Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Unpacking the ModuleQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting to the Network Connecting UTP Cables to the 5H102-48Connecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using LanviewLanview LEDs both modules CPU Is enabled and there is a Troubleshooting Checklist OFFLocal Management User’s Guide for the IP Using the Reset Button Reset Button both modulesPage Physical Properties SpecificationsModule Specifications Environmental RequirementsINPUT/OUTPUT Ports COM Port Pinout AssignmentsRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Page Index NumericsIndex-2