Enterasys Networks 5H103-48, 5H102-48 manual Completing the Installation

Page 34

Completing the Installation

3.Tighten the two screws on the RJ21 connector, as applicable, to secure it to the module.

If using the RJ21 angle adapter, plug in the RJ21 right-angled connector until the two retaining clips, shown in Figure 3-7, snap into place.

NOTE: The cable pinouts for a 25-pair cable (RJ21) can be found in the Cabling Guide. Refer to Related Documents in About This Guide for details on how to obtain this document.

4.Verify that a link exists by checking that the port Link LEDs are on (flashing amber, blinking green, or solid green). If any of the Link LEDs are off, perform the following steps until they are on:

a.Verify that the device at the other end of the twisted pair segment is ON and connected to the segment.

b.Verify that the RJ21 connectors on the twisted pair segment have the proper pinouts and check the cable for continuity.

c.Check that the twisted pair connection meets the specifications in the Cabling Guide.

If a link is not established, contact Enterasys Networks. Refer to Getting Help in About This Guide for details.

5.Repeat all the steps above until all RJ21 connections are made.

3.4COMPLETING THE INSTALLATION

After installing the module and making the connections to the network, proceed as follows:

1.If the chassis is installed in a rack that has strain-relief brackets, secure the cables by running the cables along the strain-relief bracket and tying them to the bracket using cable ties.

2.The module is now ready to be configured through Local Management. Refer to the MATRIX E5 Series Modules Local Management User’s Guide for information on how to access and use Local Management. For details on how to get manuals, refer to the Related Documents section in About This Guide.

3-10Installation

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement IiiPage Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents Document Conventions Guide uses the following conventionsGetting Help Your email addressIntroduction Introduction5H102-48 and 5H103-48 Modules Port Trunking ConnectivityHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Remote Monitoring Rmon802.1 Port Priority PORT/VLAN Redirect FunctionFlow Control ManagementSwitching Options Standards CompatibilityPage Network Requirements Port Trunking Feature10BASE-T Network 100BASE-TX Network Installation Unpacking the ModuleQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting to the Network Connecting UTP Cables to the 5H102-48Connecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using LanviewLanview LEDs both modules CPU Is enabled and there is a Troubleshooting Checklist OFFLocal Management User’s Guide for the IP Using the Reset Button Reset Button both modulesPage Physical Properties SpecificationsModule Specifications Environmental RequirementsINPUT/OUTPUT Ports COM Port Pinout AssignmentsRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Page Index NumericsIndex-2
Top Page Image Contents