Enterasys Networks 5H103-48, 5H102-48 manual FCC Notice, Industry Canada Notice, Vcci Notice

Page 4

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

INDUSTRY CANADA NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

ii

Image 4
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement IiiPage Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents Document Conventions Guide uses the following conventionsGetting Help Your email addressIntroduction Introduction5H102-48 and 5H103-48 Modules Connectivity HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONPort Trunking Remote Monitoring RmonPORT/VLAN Redirect Function Flow Control802.1 Port Priority ManagementSwitching Options Standards CompatibilityPage Network Requirements Port Trunking Feature10BASE-T Network 100BASE-TX Network Installation Unpacking the ModuleQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting to the Network Connecting UTP Cables to the 5H102-48Connecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using LanviewLanview LEDs both modules CPU Is enabled and there is a Troubleshooting Checklist OFFLocal Management User’s Guide for the IP Using the Reset Button Reset Button both modulesPage Specifications Module SpecificationsPhysical Properties Environmental RequirementsINPUT/OUTPUT Ports COM Port Pinout AssignmentsRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Page Index NumericsIndex-2