Enterasys Networks 5H102-48, 5H103-48 manual Setting the Mode Switches

Page 49

Setting the Mode Switches

Switch 6 – No function.

Switch 7 – Clear NVRAM. Changing the position of this switch resets NVRAM on the next power-up of the device. All user-entered parameters, such as the IP address, device names, etc., are reset to the factory default settings. Once the module resets, you can either use the factory default settings or reenter your own parameters.

Switch 8 – Reset Password/Community Names. Changing the position of this switch clears user-entered passwords stored in NVRAM, and restores the factory default passwords on the next power-up of the device. Once the module resets, you can either use the factory default settings or reenter your own passwords.

NOTE: Do not change the position of Switch 8 unless it is necessary to reset the super-user configured passwords to their factory default settings.

Mode Switch Bank Settings and Options

B-3

Image 49
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Iii Enterasys NETWORKS, INC Program License AgreementPage Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents Guide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction5H102-48 and 5H103-48 Modules HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION ConnectivityPort Trunking Remote Monitoring RmonFlow Control PORT/VLAN Redirect Function802.1 Port Priority ManagementStandards Compatibility Switching OptionsPage Network Requirements Port Trunking Feature10BASE-T Network 100BASE-TX Network Unpacking the Module InstallationQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting UTP Cables to the 5H102-48 Connecting to the NetworkConnecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview TroubleshootingLanview LEDs both modules CPU Is enabled and there is a OFF Troubleshooting ChecklistLocal Management User’s Guide for the IP Reset Button both modules Using the Reset ButtonPage Module Specifications SpecificationsPhysical Properties Environmental RequirementsCOM Port Pinout Assignments INPUT/OUTPUT PortsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Page Numerics IndexIndex-2