Enterasys Networks 5H102-48, 5H103-48 manual Introduction

Page 17

1

Introduction

This chapter introduces the 5H102-48 and 5H103-48 Fast Ethernet modules.

Important Notice

Depending on the firmware version used in the module, some features described in this document may not be supported. Refer to the Release Notes shipped with the module to determine which features are supported.

The 5H102-48 module (Figure 1-1) features 48 10BASE-T/100BASE-TX switched ports connected through 48 RJ45 front panel connectors.

The 5H103-48 module (Figure 1-1) features 48 10BASE-T/100BASE-TX switched ports connected through 4 RJ21 front panel connectors.

Each of the fixed front panel ports can operate in either half-duplex or full-duplex mode of operation, as determined by auto-negotiation. Full-duplex can also be manually configured.

The module ports can be configured to control traffic in several ways, including prioritizing traffic flow according to protocol type. The module can also be configured to establish 802.1Q Virtual Local Area Networks (VLANs) and control the flow of frames associated with each VLAN according to priority and Ether type. Detailed information about VLANs is provided in the MATRIX E5 Series Modules Local Management User’s Guide .

The module receives power and backplane connectivity when it is inserted into a 5C105 MATRIX E5 chassis.

Introduction 1-1

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Vcci Notice FCC NoticeIndustry Canada Notice Iii Enterasys NETWORKS, INC Program License AgreementPage Declaration of Conformity Page Contents Troubleshooting Figures Tables Structure of this Guide Using this GuideAbout This Guide Related Documents Guide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction5H102-48 and 5H103-48 Modules HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION ConnectivityPort Trunking Remote Monitoring RmonFlow Control PORT/VLAN Redirect Function802.1 Port Priority ManagementStandards Compatibility Switching OptionsPage 10BASE-T Network Port Trunking FeatureNetwork Requirements 100BASE-TX Network Unpacking the Module InstallationQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting UTP Cables to the 5H102-48 Connecting to the NetworkConnecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview TroubleshootingLanview LEDs both modules CPU Is enabled and there is a OFF Troubleshooting ChecklistLocal Management User’s Guide for the IP Reset Button both modules Using the Reset ButtonPage Module Specifications SpecificationsPhysical Properties Environmental RequirementsCOM Port Pinout Assignments INPUT/OUTPUT PortsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Page Numerics IndexIndex-2
Top Page Image Contents