Enterasys Networks 5H102-48, 5H103-48 manual Module Specifications, Physical Properties

Page 43

A

Specifications

This appendix provides operating specifications for the 5H102-48 and 5H103-48 modules. Enterasys Networks reserves the right to change the specifications at any time without notice. If not specified by module name, the statistics are the same for both modules.

A.1 MODULE SPECIFICATIONS

 

Processors:

Motorola 850 SE

Dynamic Random Access

 

Memory (DRAM):

8 MB

FLASH Memory:

2 MB

A.2 PHYSICAL PROPERTIES

Dimensions:

46.43 H x 6.05

W x 29.51

D (cm)

 

18.28 H x 2.38

W x 11.62

D (in)

Approximate Weight (Unit):

2.04 kg (4.5 lb)

 

MTBF (Predicted):

 

 

 

5H102-48

224,246 hours

 

 

5H103-48

225,115 hours

 

 

A.3 ENVIRONMENTAL REQUIREMENTS

Operating Temperature:

5°C to 40°C (41°F to 104°F)

Storage Temperature:

-30°C to 73°C (-22°F to 164°F)

Operating Relative Humidity:

5% to 90% (non-condensing)

Specifications A-1

Image 43
Contents 5H102-48 and 5H103-48 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Iii Enterasys NETWORKS, INC Program License AgreementPage Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents Guide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction5H102-48 and 5H103-48 Modules Remote Monitoring Rmon ConnectivityHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Port TrunkingManagement PORT/VLAN Redirect FunctionFlow Control 802.1 Port PriorityStandards Compatibility Switching OptionsPage Network Requirements Port Trunking Feature10BASE-T Network 100BASE-TX Network Unpacking the Module InstallationQuantity Installing the Module Into the 5C105 Chassis Installing a Module into the 5C105 Chassis Connecting UTP Cables to the 5H102-48 Connecting to the NetworkConnecting a Twisted Pair Segment to the 5H102-48 Crossover Cable RJ45 Pinouts Connecting UTP Cables to the 5H103-48 Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview TroubleshootingLanview LEDs both modules CPU Is enabled and there is a OFF Troubleshooting ChecklistLocal Management User’s Guide for the IP Reset Button both modules Using the Reset ButtonPage Environmental Requirements SpecificationsModule Specifications Physical PropertiesCOM Port Pinout Assignments INPUT/OUTPUT PortsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Page Numerics IndexIndex-2