ENGLISH
Step 6: Add Safety Bolts (Tilting Monitor Brackets only)
Thread a Safety Bolt (I) into the bottom portion of each Tilting Monitor Bracket (D & E) approximately 1/4″ as shown in Diagram 6.
NOTE: Do not tighten the Safety bolt (I). The Safety Bolt is tightened after the television and Tilting Monitor Brackets (D & E) are attached to the Wall Plate Assembly (A).
Diagram 6
D & E
I
Step 7: Configure Wall Plate Assembly
The Wall Plate Assembly (A) can be adjusted in width from 27″ to 42″ [686 mm to 1067 mm]. Determine how wide you want the Wall Plate Assembly based on the following criteria:
•Width of television (Wall Plate Assembly should be configured so the total width is less than the overall width of your television)
•Width of Hole Pattern on television (Wall Plate Assembly should be wider than the horizontal distance between threaded inserts on the back of your TV by at least 2″ [50.8 mm])
•Stud Spacing (Sanus recommends attaching Wall Plate Assembly to three studs for televisions over 125 lbs. [56.7 Kg])
To adjust the width of the Wall Plate Assembly (A):
Remove each Flange Nut and Nylon Washer as shown in Diagram 7A
Remove the Center Plate of the Wall Plate Assembly (A) as shown in Diagram 7B.
Seperate the Left and Right Extension of the Wall Plate Assembly (A) and set them to so that their outer edges are equal to the desired width; then, insert the Center Plate so the teeth on its bottom fit into the slots in the Left and Right Extension, making sure that the Threaded Studs fit through the center row on holes in the Center Plate as shown in Diagram 7C.
Nylon | Diagram 7A |
| |
Washer |
|
Flange |
|
Nut |
|
| Diagram 7B |
Diagram 7C
Left 
Center
ExtensionPlate
Wall Plate
Assembly (A)
Center
Plate
Right
Extension
Threaded
Studs
VMPL3_051106_ML.indd 10
7/17/06 11:37:14 AM