Diagram 8B Flange Nut | Sanus Systems VMPL3 instruction

CAUTION: All four Threaded Studs must pass through			Diagram 7D
the Center Plate for the installation to be safe.				Right
Using the previously	removed Flange Nuts and Nylon			Extension
Using the previously	removed Flange Nuts and Nylon
Washers, secure the	Right and Left Extension to the Center
Plate as shown in Diagram 7D, and securly tighten the Flange
Nuts.
	Left
	Extension	Center
		Center	Flange
		Plate	Flange	Nylon
			Nut	Nylon

Washer

Step 8: Mount the Wall Plate Assembly; Wood Stud, Brick, Solid Concrete, and Concrete Block mounting options are provided.

CAUTION: On all installations, two Lag Bolts (K) must pass through each Wall Plate Extension. Only the fifth and sixth Lag Bolts may pass through the Center Plate (A).

Wood Stud Mounting:	Diagram 8A	Flange
		Flange
CAUTION: Do not overtighten the Lag Bolts (K). Tighten		Nut
the Lag Bolts only until the lag Bolt Washer (L) is pulled
firmly against the Wall Plate Assembly (A).

NOTE: The Wall Plate Assembly (A) must be mounted on two or three studs at least 12″ [304.8 mm] apart, and three studs are recommended for televisions over 125 lbs [56.7 Kg].

	Use a high quality stud sensor to locate two or three adjacent	L
	studs; then, using the Wall Plate Assembly (A), as a template,	L
		K
	mark a location at each of the studs using the top row of slots	A
	on the Wall Plate Assembly and the corresponding slot in the	A
	bottom row.

Pre-drill a 2.5″ [63.5 mm] deep into the studs, using a 3/16″ drill bit. Place the Wall Plate Assembly (A) with its flat surface against the wall and the Flange Nuts toward the top; then secure the Wall Plate Assembly using the Lag Bolts (K) and Lag Bolt Washers (L) as shown in Diagram 8A.

ENGLISH

Brick, Solid Concrete, and Concrete Block Mounting:

Use the Wall Plate Assembly (A) as a template to mark six locations on the wall. Three in the top row of slots and three more directly below in the bottom row of slots.

CAUTION: Never drill into the mortar between the blocks.

Carefully pre-drill six 2.5″ [63.5 mm] deep holes with a 1/2″ masonry bit.

Insert a Concrete Anchor (M) into each pre-drilled hole so it is flush with the concrete, brick, or concrete block surface, even if there is a layer of drywall or other material in front of the surface.

Place the Wall Plate Assembly (A) with its flat surface against the wall and the Flange Nuts toward the top; then, attach the Wall Plate Assembly to the wall using the six Lag Bolts (K) and Lag Bolt Washers (L) as shown in Diagram 8B.