Runco SP-50DHD, SP-42DHD, SP-60DHD manual Operation, Turning on the Power

4. Operation

1.Turn on your source components.

2.Plug the female end of the power cord into

the AC receptacle on the rear of the PlasmaWall. Connect the other end to your AC power source.

3.Similarly connect the DHD Controller to a nearby AC outlet.

4.Set the main power switch at the rear of the PlasmaWall (see Figure 2-2)to the “on” position. Its power indicator lights red.

5.Set the main power switch at the rear of the DHD Controller (see Figure 2-6)to the “on” position.

6.Press the ON button on the remote control to turn on the DHD Controller and PlasmaWall (or

press the power button on the front of the DHD Controller). The power indicator on the DHD Controller lights solid blue.

7. After a brief warm-up period (approximately 10 seconds), the PlasmaWall will display an image.

4.1

Turning on the Power

PlasmaWall SP Series Owner’s Operating Manual 31