Tuner Setup Menu, Setting AIR/CABLE Option

SETUP MENU (CONTINUED)

TUNER SETUP MENU:

Select TUNER SETUP using the Navigation (Ã,¨) buttons, then select/change the setup option as described on page 18. This unit is equipped with a channel memory feature which allows channels to skip up or down to the next channels set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the unit’s memory. In addition to normal VHF/UHF channels, this unit can receive up to 125 Cable TV channels. First set the AIR/CABLE option, then follow the steps in Auto Channel scan below.

SETTING AIR/CABLE OPTION

AUTO CHANNEL SCAN

Start auto scan channel	3	Start auto scan channel
TUNER		TUNER

3	Air	SCAN	CH	Skip		Air	SCAN	CH	Skip
2	2		002			2		002
			003		1	2		003
			003			1		003
			004					004
			004					004
			005					005
			006					006
			007					007

Press the SETUP button ❶ to enter the Setup Menu. Select the TUNER Setup icon at the top of the screen using the Navigation (Ã,¨) buttons ❷, then press the ENTER button 3 to select it. Press the ENTER button 3 again to select the Air/Cable pull down menu. Select AIR or CABLE using the Navigation (¹, ) buttons 2, then press the ENTER button 3.

Select CABLE if using cable television or AIR if using an outdoor antenna.

Follow the steps in Setting Air/Cable Option, then select SCAN using the Navigation (Ã,¨) buttons 1 followed by the ENTER button 2; the unit will then automatically cycle through all the channels and store active channels into memory. All non-active channels will be marked with a check in the Skip column.

NOTES:

•During Auto Scan, press the Stop (■) button 3 to cancel searching.

•It is highly recommended to perform the Auto Channel Scan to scan all channels and store the active channels into memory when first using the set. The "TUNER" option may not be available if no channel or station is found.

ADDING/SKIPPING CHANNELS

1
Start auto scan channel
	TUNER
Air	SCAN	CH	Skip
		002
		003
		004
		005
		006
		007

After setting channels into memory, you can add or skip channels. Scroll to the Skip column and you will see that all skipped channels have a check next to them. To add or skip a channel, simply select the check box next to the channel number and press the ENTER button to skip (a checkmark will appear) or add (a checkmark will disappear).

ADDING/SKIPPING CHANNELS NOTE:

To View the channel, use the Navigation (Ã,¨,¹, ) button to select the CH number, then use the Number buttons to enter the desired channel number (or use the Navigation ¹, button to select the desired channel). Press the ENTER button to view that channel under the setup menu on the TV screen.